Settings and Adjustments
43
GB
[16bit], [12bit], [10bit]: Outputs 16bit/12bit/
10bit video signals when the connected TV is
compatible with Deep Colour.
[Off]: Select this when the picture is unstable or
colors appear unnatural.
x [SBM] (Super Bit Mapping)
[On]: Smooths the gradation of video signals
output from the HDMI (OUT) jack.
[Off]: Select this when outputting distorted
video signals or unnatural color.
x [Pause Mode] (BD/DVD VIDEO/DVD-R/
DVD-RW only)
[Auto]: The picture, including subjects that
move dynamically, is output with no jitter.
Normally select this position.
[Frame]: The picture, including subjects that do
not move dynamically, is output in high
resolution.
[Audio Settings]
x [BD Audio MIX Setting]
[On]: Outputs the audio obtained by mixing the
interactive audio and secondary audio to the
primary audio.
[Off]: Outputs the primary audio only.
x [Audio DRC]
You can compress the dynamic range of the
sound track.
[Auto]
: Performs playback at the dynamic range
specified by the disc (BD-ROM only).
[On]: The system reproduces the sound track
with the kind of dynamic range that the
recording engineer intended.
[Off]: No compression of dynamic range.
x [Attenuate - AUDIO]
Distortion may occur when you listen to a
component connected to the AUDIO (AUDIO
IN L/R) jacks. You can prevent distortion by
attenuating the input level on the unit.
[On]
: Attenuates the input level. The output
level will decrease at this setting.
[Off]: Normal input level.
x [Audio Output]
You can select the output method where the
audio signal is output.
[Speaker]: Outputs multi-channel sound from
the system’s speakers only.
[Speaker + HDMI]
: Outputs multi-channel
sound from the system’s speakers and 2-channel
linear PCM signals from the HDMI (OUT) jack.
[HDMI]: Outputs sound from the HDMI (OUT)
jack only. Sound format depends on the
connected component.
• When [Control for HDMI] is set to [On] (page 45),
[Audio Output] is set to [Speaker + HDMI]
automatically and this setting cannot be changed.
• Audio signals are not output from the HDMI (OUT)
jack when [Audio Output] is set to [Speaker + HDMI]
and [HDMI1 Audio Input Mode] (page 45) is set to
[TV]. (Europe models only.)
• When [Audio Output] is set to [HDMI], the output
signal format for the “TV” function is 2-channel
linear PCM.
x [Sound Effect]
You can set the system’s sound effects (SOUND
MODE setting
(page 23)) on/off.
[Sound Mode On]: Enables the surround effect
of the sound mode (page 23). The sampling
frequency upper limit is set to 48 kHz.
[Off]: The sound effects are disabled. You can
hear sound as it is recorded.
x [Speaker Settings]
To obtain the best possible surround sound, set
the speakers. For details, see “Setting the
Speakers” (page 35).
To Next Page
Loading...
