Settings and Adjustments
45
GB
[System Settings]
x [OSD Language]
You can select your language for the system on-
screen displays.
x [Illumination/Display]
You can select the status of the soft-touch
buttons (page 10) and front panel display
(page 11).
[On]: The soft-touch buttons and the front panel
display stay illuminated.
[Auto]: The soft-touch buttons and the front
panel display turn off when the system is not
being operated.
x [Remote Sensor]
You can select the remote sensor to be used
according to the installation position of the main
unit.
[Vertical/Horizontal]
: Both the remote sensors
are active. The one in the vertical position has
priority.
[Vertical]: Only the remote sensor in the vertical
position is active.
[Horizontal]: Only the remote sensor in the
horizontal position is active.
x [HDMI Settings]
[Control for HDMI]
[On]
: On. You can operate mutually between
components that are connected with an HDMI
cable.
[Off]: Off.
[Audio Return Channel]
This function is available when you connect the
system to a TV’s HDMI IN jack that is
compatible with the Audio Return Channel
function.
[Auto]
: The system can receive the digital audio
signal of the TV automatically via an HDMI
cable.
[Off]: Off.
• This function is available only when [Control for
HDMI] is set to [On].
[HDMI1 Audio Input Mode] (Europe models
only)
You can select the audio input of the component
that is connected to the HDMI (IN 1) jack.
[HDMI1]: The sound of the component that is
connected to the HDMI (IN 1) jack is input from
the HDMI (IN 1) jack.
[TV]: The sound of the component that is
connected to the HDMI (IN 1) jack is input from
the TV (DIGITAL IN OPTICAL) jack.
x [Quick Start Mode]
[On]: Shortens the startup time from standby
mode. You can operate the system quickly after
turning it on.
[Off]
: The default setting.
x [Power Save Drive]
[On]: Reduces power consumption when
volume level is low.
[Off]: Normal status. The system can output
sound volume.
x [Auto Standby]
[On]: Turns on the [Auto Standby] function.
When you do not operate the system for about
30 minutes, the system enters standby mode
automatically.
[Off]: Turns off the function.
x [Auto Display]
[On]: Automatically displays information on the
screen when changing the viewing titles, picture
modes, audio signals, etc.
[Off]: Displays information only when you
press DISPLAY.
x [Screen Saver]
[On]: Turns on the screen saver function.
[Off]: Off.
In a horizontal
position
In a vertical
position
To Next Page
Loading...
