13
Location and Function of Parts
m CTRL (control) connector (RJ-45)
Connect to an Ethernet switch.
The MVS-8400/8300/8200 Switcher Processor Pack, the
MVE-8000 DME Processor Pack and other devices are
connected in the same way to the Ethernet switch to form
a network for exchange of signals between the devices.
This network is used primarily to control the various
devices from the center control panel.
n EXT (extension) DISPLAY connector
(high-density D-sub 15-pin, analog RGB)
This connector is reserved for future system expansion.
o MENU PANEL connector (D-sub 50-pin,
special interface)
Connect to the menu panel.
Caution
For safety, do not connect the connector for peripheral
device wiring that might have excessive voltage to the
following ports.
• PERIPH (peripheral) connector
• DATA connector
• CTRL (control) connector
Follow the instructions for the above ports.
To Next Page
Loading...
