21
Exchanging Button Labels
The number of modules that can be connected to a single
MKS-8010/8010A System Control Unit is as follows.
(The maximum number of adaptors that can be connected
on 1 channel is 8.)
However, it is not possible to connect four Key Control
Modules and a 10 Key Pad Module on one channel.
You can also connect a keyboard, mouse, pen tablet and
other devices with USB connectors to the DEVICE
connectors of the main panel regardless of whether an
MKS-8025/8025MS has been installed in the main panel
or installed apart from the main panel using an MKS-8076
adaptor, or to the DEVICE connectors of a module to
operate the MKS-8025/8025MS.
Contact your Sony service representative for more
information about connectable devices.
Note
To make connections to the EXT PANEL 1, 2 and 3
connectors, MAIN PANEL connector, and MENU
PANEL connector on the MKS-8010/8010A System
Control Unit, always use the cables supplied in the
package, or SWC-5005 or SWC-5010 cables.
Exchanging Button
Labels
A button top puller is supplied with the center control
panel.
After changing a pattern assigned to a numeric button, you
can use the following procedure to exchange the button
label.
1
Write the new pattern on one of the supplied exchange
labels.
2
Grip the holes on the button sides with the supplied
button top puller and remove the button.
3
Grip the slots on the sides of the white button cap with
the button top puller, so that the cap flexes slightly,
and remove the cap.
4
Remove the old label and insert the new label.
5
Replace the button cap.
6
Replace the button in its original location.
Model Module name Max. modules
MKS-8013/8013B/
8014/8014B/8015/
8015B
32, 24, 16 AUX Bus
Module
2
MKS-8026 10 Key Pad Module 1
MKS-8030 Key Frame Module 1
MKS-8031JS Joystick Module 1
MKS-8031TB Track Ball Module 1
MKS-8033 Utility/Shotbox Module 2
MKS-8035 Key Control Module 4
MKS-8032 DSK Fader Module 4
23
To Next Page
Loading...
