Sony CDP-715 - Disassembly Procedures; Front Panel Disassembly; MD (BU-5 BD10 B) Disassembly

SECTION 3
DISASSEMBLY
Note : Follow the disassembly procedure in the numerical order
given.
3-1. FRONT PANEL
* When removing the front panel assembly on electric power
failure, first open the loading block by turning cam with a
screwdriver as shown in the figure, next pull out the load-
ing block with hand, and remove the loading panel as
shown in the figure, Then remove the front panel
assembly.
bottom of chassis
@ Turn in the direction
of the arrow.
@ Remove loading panel in the arrow direction.
@ Pull out side table.
3-2. MD (BU-5BD10B)
@ Turn the cam to the direction of arrow (Counter clock
wise) by minus screw driver.
@ Take off the disc table. @ BU-58D10B
@ Yoke bracket
© Remove the yoke bracket. oe
@
Remove
the
MD
(BU-5BD10B)
to
the
direction
of
8
arrow.