Sony CDP-C211 - Programming Whole Discs; Managing Programmed Selections

You can make a program for both sides (side A and side
B) of the tape at one time.
* You can program one selection or one disc in a step.
To program a whole disc
¢ Using the DISC 1 to 5 buttons
After steps 1 and 2:
1 Press the DISC 1 to 5 buttons to select the disc.
2 Go on to step 6.
¢ Using the DISC SKIP button
After steps 1 and 2:
1 Press DISC SKIP button. “AL” is displayed in the
window.
2 Press PROGRAM.
3 Go on to step 6.
The whole disc is programmed as one step.
To program while observing the disc labels
You can program the selections with the disc compartment
open.
To play the selections for side B
When the selections for side A have been played, the unit
will pause. (“B” lights up.)
7 the tape to the beginning of side B, then press > or
a
The selections for side B will start playing.
To stop program play
Press &. The last selection number programmed will be
displayed.
To resume play, press B>. Play begins from the beginning
of the program.
You can play the same program repeatedly as long as you
do not cancel program play or erase the program.
To cancel program play
Press CONTINUE and return to the continuous playing
mode. The program will be erased.
Skipping to the next selection programmed
Press PP during play.
Going back to the beginning of the selection being played
Press I¢4 during piay.
Display on step 3 (procedure step display)
O23 45
:
466
1234
678a09
ee
ie
econ Ff
20
iy
1234
6789
W128 6
ieee
~, =!
To erase all the selections programmed
Press @ to erase.
For CDP-C315 only hi
To check your program
Press CHECK. The first selection in the program will be
displayed.
Each time you press CHECK, the next selection in the
program will be displayed. When CHECK is pressed after
the last selection, “End” appears and then the display
returns to the initial display.
To erase the last selection, press CLEAR.
Each time you press CLEAR, the last selection in the
program will be erased.
To delete a selection, press CHECK repeatedly until the
undesired selection is displayed. Then press CLEAR.
The program will be erased in the following situations
¢ & is pressed during program play.
© Power is turned off.
To check the step of programmed selections
Press TIME during stop mode.
The number of programmed selections will be displayed for few
seconds in the window.
To check the remaining time
Press TIME once to see the remaining time of the selection being
played; twice to return to the initial display.
The total remaining time cannot be displayed.
If you have programmed a selection number over 20, numeric of
STEP is displayed instead of the remaining time.
Notes
¢ The playing time for selection numbers higher than 20 will not
be added into the total playing time.
© When selections have been programmed for sides A and B, the
total playing time displayed during stop mode will show the
selections programmed for side B and the total playing time for
side B.
13