Sony CDP-C401 - Troubleshooting Guide

Bhcelele)(-tJareledilareMmelei(ey-
The
following
checks
will
assist
in
the
correction
of
most
problems
which
you
may
encounter
with
your
unit.
Should
any
problem
persist
after
you
have
made
these
checks,
consult
your
nearest
Sony
service
facility.
Before
going
through
the
check
list
below,
first
refer
back
to
the
connection
and
operating
procedures.
Trouble
No
audio
from
one
or
both
channels
Incorrect
operation
of
the
amplifier
Operate
correctly
Connect the cords firmiy.
Play
does
not
begin.
No
disc
in
the
disc
compartment
Put
disc(s)
in
the
compartment.
The
player
is
in
the
pause
mode
Press
PII
(or
Il
on the
remote
commander)
to
release
pause.
Moisture
condensation
Leave
the
player
turned
on
for
about
an
hour.
The
disc
is
set
upside
down.
Set
the
disc
with
the
label
side
up.
The
disc
is
tilted.
Set
the
disc
correctly
The
disc
is
extremely
dirty.
Clean
the
disc.
Play did not start from the disc in the | Press DISC 1 to start play.
DISC 1 tray.
The batteries are exhausted. Replace both batteries.
The
remote
commander
is
not
pointed
|
Point
the
remote
commander
to
the
at
the
remote
control
sensor.
sensor.
There
is
an
obstacle
between
the
Remove
the
obstacle.
remote commander and the unit.
The remote commander is too far from | Move closer.
the unit.
The internal control program may not | Turn OFF the power and turn it ON
run. again.
Discs cannot be played continuously.
Remote commander does not operate
the unit.
(For CDP-C500 and CDP-C44 only).
Any operation is not possible.
15