Sony CDP-CX355 - Playing Using a Timer

Playing CDs
6 To program other discs/tracks, do the following:
To program Repeat Steps
All tracks of another disc(s) 2 to 4
Other tracks on the same disc
5
Other tracks on other discs 2 to 5
Playing Using a Timer
You can start playing a disc at any given time by
connecting a timer (not supplied). Refer also to the
instructions for the timer
if you need help.
7 Press C> to start Program Play.
To cancel Program Play
Press CONTINUE.
Checking the programmed order
TIMER
Play mode buttons
I
=
@~
c:;:=)t=l~C)
~c::::Jc::::Jr==J
EH~ !··I·I
You can check your program before or after you start
playing.
Press CHECK.
Each time you press this button, the display shows the
disc
and track number of each step in the programmed
order. (When a whole disc is programmed as one step,
"ALL" appears instead of the track number.) After the
last step in the program, the display shows
"- END-"
and returns to the original display.
Changing the programmed order
You can change your program before you start playing.
1 Press one of the play mode buttons to select the
desired play mode.
2 Set TIMER on the player to PLAY.
3 Set the timer to the desired time.
The player turns off. When the set time comes, the
player turns on and starts playing.
4 After you have used the timer, set TIMER on the
player to OFF.
To
Erase a track or disc
Erase the last track or
disc in the program
Add tracks or discs to the
end of the program
Change the whole
program completely
You need to
Press CHECK until the track or
disc you do not want appears in
the display, then press
CLEAR
Press CLEAR. Each time you
press the button. the last
programmed track or disc will be
cleared.
Follow the programming
procedure
Hold
down CLEAR until
"CLEAR" appears in the display
to erase the whole program, then
create a new program following
the programming procedure
Erasing the program stored in memory
1 Press PROGRAM repeatedly in the stop mode
until the program number (PROGRAM
1, 2, or 3)
you want to erase appears in the display.
2 Hold down CLEAR until "CLEAR" appears in the
display.