Sony CDP-CX355 - Getting Started; Unpacking; Hooking up the System

, " Getting Started
x ,iUidi
Unpacking
Hooking Up the System
Check that you received the following items:
•
Audio cord (1)
• Remote commander (remote) (1)
• Size AA (R6) batteries (2)
Overview
This section describes how to hook up the CD player to
an amplifier. Be sure to turn off the power of each
component before making the connections.
To an AC outlet
-"'"~. White
(L)
-""''''''''''. Red
(R)
DIGITAL OUT
(OPTICAL)
CD player
- ..... COMMAND MODE
To ANALOG OUT (R)
: Signal flow
White
(L)
Red
(R)
CONTROL A1 IT
To audio input
To ANALOG OUT (L)
To an AC outlet
What cords willi need?
Audio cord (1) (supplied)
Inserting batteries into the remote
You can control ~he player using the supplied remote.
Insert
two size AA (R6) batteries (supplied) by
matching the
+ and - on the batteries to the diagram
inside the battery compartment.
Insert the negative (-) end first, then
push in and down
until the positive (+) end clicks into position.
When using the remote, point it at the remote sensor
11
on the player.
'Q' When to replace batteries
With normal use, the batteries should last for about six
months. When the remote no longer operates the player,
replace all the batteries with new ones.
Notes
• Do not leave the remote near an extremely hot or humid
place.
• Do not
drop any foreign object into the remote casing,
particularly when replacing the batteries.
• Do not expose the remote sensor to direct sunlight or
lighting apparatuses. Doing so may cause a malfunction.
• If you do not use the remote for an extended period of time,
remove the batteries
to avoid possible damage from battery
leakage and corrosion.