Playing
CDs
Controlling Another
CD
Player
(Advanced
Mega
Control)
1 Press MEGA CONTROL on this player.
The MEGA CONTROL
button
and "2nd" in the
display light up. The display
shows
the current
disc
number
or
disc memo
of
the second player.
I
Current disc number
or
the
Disc
Memo
To
control
the master
player
again
Press MEGA CONTROL. The MEGA CONTROL button goes
off and you can control the master player.
2 Select the desired play mode.
To program tracks, use the controls
on
the second
player.
4
COl
2nd DISC
1*0
..
<1
.S
C
·~4.~,
ALL DISCS
3 Press
t>
on
this player to start playing.
While the MEGA CONTROL
button
is lit, you can
control the second player with the controls
on
this
player.
To
control
the
second
player
directly
using
the
supplied
remote
Set CD
1(2(3
on the remote to CD 3 which
is
the same
position as the COMMAND MODE selector on the rear panel
of the second player.
This unit can control a second CD player (see
"Connecting Another CD Player" on page
6).
Even
when
a second CD player is connected, the
controls on both of the units will function. When you
press the play
button
on either unit, the operating
player stops and the resting player starts.
Make sure "2nd DETECTED" appears in this player's
display after turning on
both
players.
Note that depending on the player,
you
may
not
be
able to operate all the functions of the second CD
player.
I
MEGA CONTROL
c>
II
Play
mode buttons
(CONTINUE/SHUFFLE/
PROGRAM/REPEAT)
KI<J
AMS
l>I>{]
MENU/NO
JOG
The controls indicated in the illustration below are effective
while the MEGA CONTROL button
is
lit.
000
000
000
000
000
000
000
000
000
I
[>
I
00
88
818
80
COMMAND
MODE selector
To Next Page
Loading...
