Sony CDX-540RF - Page 11

11
FM BOARD
MAIN BOARD, SLIDE VARIABLE RESISTOR (ELEVATOR HEIGHT SENSOR ) (RV202)
1 screw
(BVTT2.6
× 6)
3 cover
(FM connector.T)
2 screw
(ground)
4 cover (FM)
5 FM boar
d
1 main flexible board
(CNJ101)
5 two screws (FP)
6 screw
(PTT2 × 4)
7 main board
2 Remove two solders of
the elevator motor leads (M104).
2 Remove three solders
of the slide variable resistor
(RV202).
2 Remove four solders of
the SW board leads.
3 screw (PTT2 × 4)
4 heat sink (T)
9 slide variable resistor
(elevator height sensor)
(RV202)
8 screw
(PTT2 × 4)