EasyManua.ls Logo

Sony CDX-GT222 - Page 28

Sony CDX-GT222
38 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
28
CDX-GT121/GT220/GT222
61 CODEC_SEL I MP3 select signal input “H”: MP3, “L”: Non-MP3
62 ILLUMI SEL I Illumination voltage setting signal input “H”: 10.4 V, “L”: 9.0 V
63 NCO O Not used. (Open)
64 SIRCS I Remote control signal input
65 to 67 NCO O Not used. (Open)
68 FLASH_W I
Memory mode select signal input Not used in this set. (Pull up)
Normally “H” input: Single chip mode, after reset “L”: Flash write mode
69, 70 NCO O Not used. (Open)
71 RC_IN1 I Rotary commander shift key signal input Not used in this set. (Pull up)
72 ACC_IN I Accessory power supply detect signal input
73 TESTIN I Test mode detect signal input
74 TELATT I Telephone attenuate detect signal input
75 NCO O Not used. (Open)
76 AD_ON O A/D converter power supply control signal output
77 RESET I System reset signal input
78 NCO O Not used. (Open)
79 XOUT O Low speed operation clock signal output (32.768 kHz)
80 XIN I Low speed operation clock signal input (32.768 kHz)
81 VSS1 Ground pin
82 OSCIN I High speed operation clock signal input (18.432 MHz)
83 OSCOUT O High speed operation clock signal output (18.432 MHz)
84 VCC3 Power supply pin (+3.3 V)
85 DEMOSEL I DEMO select signal input “H”: DEMO on, “L”: DEMO off
86 ATT O Audio mute control signal output
87 BUSON O BUS ON signal output
88 SYSRST O System reset signal output
89 to 92 NCO O Not used. (Open)
93 Z-MUTE I CD zero cross mute detect signal input
94 B OUT SEL I Black out with/without discrimination select signal input “H”: Black out
95 INI RS I REAR/SUB INITIAL setting signal input “H”: REAR INITIAL, “L”: SUB INITIAL
96 MO-DISP I Motion display signal input “H”: Motion display on, “L”: Motion display off
97 DIM_SEL I
Dimmer select signal input “H”: Dimmer, “L”: No dimmer
Not used in this set. (Pull down)
98 CD_ON I CD mechanism servo power supply control request signal input
99 CDM_ON I CD mechanism deck power supply control request signal input
100 COL_SW I
Illumination color select signal input Not used in this set. (Pull down)
“H”: Two colors selection/initial slave, amber, “L”: Color/slave, amber
Pin No. Pin Name I/O Pin Description

Other manuals for Sony CDX-GT222

Related product manuals