31
CDX-GT450U/GT454US
SECTION 6
ELECTRICAL PARTS LIST
KEY BOARD
**********
1-780-789-12 CONDUCTIVE BOARD, CONNECTION
4-183-279-01 ILLUMINATOR (LCD)
< CAPACITOR >
C901 1-107-826-11 CERAMIC CHIP 0.1uF 10% 16V
C902 1-107-826-11 CERAMIC CHIP 0.1uF 10% 16V
C903 1-107-826-11 CERAMIC CHIP 0.1uF 10% 16V
C904 1-125-891-11 CERAMIC CHIP 0.47uF 10% 10V
C906 1-107-826-11 CERAMIC CHIP 0.1uF 10% 16V
C909 1-162-927-11 CERAMIC CHIP 100PF 5% 50V
C910 1-162-927-11 CERAMIC CHIP 100PF 5% 50V
C911 1-162-927-11 CERAMIC CHIP 100PF 5% 50V
C912 1-107-826-11 CERAMIC CHIP 0.1uF 10% 16V
C915 1-162-964-11 CERAMIC CHIP 0.001uF 10% 50V
C916 1-162-964-11 CERAMIC CHIP 0.001uF 10% 50V
< CONNECTOR >
CN901 1-842-265-11 PLUG, CONNECTOR 20P
CN902 1-822-798-11 CONNECTOR, USB 4P (USB)
< DIODE >
D901 6-501-817-01 DIODE MA2J1110GLS0
D902 6-503-202-01 DIODE RKZ5.1B2KGP1
D907 6-503-205-01 DIODE RKZ6.8B2KGP1
D908 6-503-205-01 DIODE RKZ6.8B2KGP1
D909 6-503-205-01 DIODE RKZ6.8B2KGP1
D911 6-503-205-01 DIODE RKZ6.8B2KGP1
D912 6-503-205-01 DIODE RKZ6.8B2KGP1
D916 6-503-205-01 DIODE RKZ6.8B2KGP1
D921 6-503-205-01 DIODE RKZ6.8B2KGP1
< FERRITE BEAD >
FB901 1-414-385-21 INDUCTOR, FERRITE BEAD
FB902 1-414-385-21 INDUCTOR, FERRITE BEAD
FB903 1-414-385-21 INDUCTOR, FERRITE BEAD
< IC >
IC901 6-714-396-01 IC LC75829PWH-US-H
IC902 6-600-764-01 IC PNA4813M01S0 (IR)
< JACK >
J901 1-822-148-11 SMALL TYPE JACK (VERTICAL) (AUX)
< LIQUID CRYSTAL DISPLAY >
LCD901 1-811-224-11 DISPLAY PANEL, LIQUID CRYSTAL
< DIODE >
LED901 6-503-227-01 LED NESW505DT-A0-UV (LCD BACK LIGHT)
LED903 6-502-193-01 LED SML-D12V8WT86SN (Z)
LED905 6-502-193-01 LED SML-D12V8WT86SN
(DISC SLOT INDICATOR)
LED907 6-502-193-01 LED SML-D12V8WT86SN (ILLUMINATOR)
LED909 6-502-193-01 LED SML-D12V8WT86SN (ILLUMINATOR)
LED910 6-502-193-01 LED SML-D12V8WT86SN (SEEK+ > M)
LED912 6-502-193-01 LED SML-D12V8WT86SN (m . SEEK–)
LED914 6-502-193-01 LED SML-D12V8WT86SN (SOURCE/OFF)
LED916 6-502-193-01 LED SML-D12V8WT86SN (ZAP)
LED919 6-502-193-01 LED SML-D12V8WT86SN ( )
LED921 6-502-193-01 LED SML-D12V8WT86SN ( )
LED925 6-502-193-01 LED SML-D12V8WT86SN (RING ILLUMINATOR)
LED928 6-502-193-01 LED SML-D12V8WT86SN (RING ILLUMINATOR)
LED929 6-502-193-01 LED SML-D12V8WT86SN (RING ILLUMINATOR)
LED932 6-502-193-01 LED SML-D12V8WT86SN (ILLUMINATOR)
LED934 6-502-193-01 LED SML-D12V8WT86SN (ILLUMINATOR)
LED936 6-502-193-01 LED SML-D12V8WT86SN (ILLUMINATOR)
LED938 6-502-193-01 LED SML-D12V8WT86SN (ILLUMINATOR)
LED940 6-502-193-01 LED SML-D12V8WT86SN ( /MODE)
< SWITCH >
LSW905 1-798-287-11 SWITCH, TACTILE (WITH LED) (DSPL/SCRL)
LSW906 1-798-287-11 SWITCH, TACTILE (WITH LED) (6/PAUSE)
LSW907 1-798-287-11 SWITCH, TACTILE (WITH LED) (5)
LSW908 1-798-287-11 SWITCH, TACTILE (WITH LED) (4/SHUF)
LSW909 1-798-287-11 SWITCH, TACTILE (WITH LED) (3/REP)
LSW910 1-798-287-11 SWITCH, TACTILE (WITH LED) (2/ALBUM +)
LSW911 1-798-287-11 SWITCH, TACTILE (WITH LED) (1/ALBUM –)
LSW912 1-798-287-11 SWITCH, TACTILE (WITH LED) (PTY) (GT450U)
LSW912 1-798-287-11 SWITCH, TACTILE (WITH LED) (AF/TA/PTY)
(G T454US)
< TRANSISTOR >
Q901 8-729-038-22 TRANSISTOR RT1N140C-TP-1
< RESISTOR >
R900 1-216-864-11 SHORT CHIP 0
R904 1-216-857-11 METAL CHIP 1M 5% 1/10W
R905 1-216-864-11 SHORT CHIP 0
R906 1-216-811-11 METAL CHIP 150 5% 1/10W
Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark
KEY
Note:
• Due to standardization, replacements in
the parts list may be different from the
parts specifi ed in the diagrams or the com-
ponents used on the set.
• -XX and -X mean standardized parts, so
they may have some difference from the
original one.
• Items marked “*” are not stocked since
they are seldom required for routine ser-
vice.
Some delay should be anticipated when
ordering these items.
• CAPACITORS
uF: μF
• COILS
uH: μH
• RESISTORS
All resistors are in ohms.
METAL: Metal-fi lm resistor.
METAL OXIDE: Metal oxide-fi lm resistor.
F: nonfl ammable
• SEMICONDUCTORS
In each case, u: μ, for example:
uA. . : μA. . , uPA. . , μPA. . ,
uPB. . : μPB. . , uPC. . , μPC. . ,
uPD. . : μPD. .
When indicating parts by reference num-
ber, please include the board name.
The components identifi ed by mark 0
or dotted line with mark 0 are critical for
safety.
Replace only with part number specifi ed.
Les composants identifi és par une marque
0 sont critiques pour la sécurité.
Ne les remplacer que par une pièce por-
tant le numéro spécifi é.
To Next Page
Loading...
