8
TURNING YOUR HEADSET ON AND OFF
To turn on your headset
Press and hold down the power button for about three seconds, until a melody plays and the power indicator lights solid green for two
seconds, which indicates that the headset is on.
For detailed information about how the headset connects to devices when you turn it on, see “Connecting your headset to Bluetooth
®
devices.”
To turn off your headset
Press and hold down the power button for at least ve seconds until a melody plays and the power indicator ashes green, which indicates
that the headset is turning off. When the indicator is no longer lit, the headset is off.
CONNECTING YOUR HEADSET TO BLUETOOTH
®
DEVICES
When you turn on your Bluetooth
®
headset, it automatically tries to connect to paired devices in range of the headset. If you have paired the
headset with more than one device, the headset uses the following priority to determine which device it will connect to:
1 A PS3™ system that was paired using automatic mode (see “Pairing with the PS3™: automatic mode”). If the headset nds the PS3™
system within ve seconds, it will stop searching for other devices and connect to the PS3™ system.
2 The most recent device (PS3™ system or other Bluetooth
®
-enabled device) that the headset was connected to with which it was paired
using Bluetooth
®
discovery mode. If the headset nds the device within ve seconds, the headset will stop searching for other devices
and connect to the device. If the device is not found, the headset will go into the searching (page scan) mode.
3 To connect the headset with the next most recent device it was connected to, short press the power button. If that device is found within
ve seconds, the headset stops searching for devices and makes the connection. If this device is not found, the headset goes into
searching (page scan) mode. The user can short press the power button every 5 seconds until it connects to a device from the list of
eight most recently connected devices.
If the headset cannot nd any devices to connect to within ve minutes after it is turned on, it will turn off automatically.
TESTING AND CONFIGURING THE HEADSET
After you have connected the headset to the PS3™ system, you can verify that the PS3™ system is receiving voice input from the headset
and that the headset is correctly playing output.
To test and configure your headset
In your PS3™ system’s home menu, go to [Settings] > [Accessory Settings] > [Audio Device Settings].
After you pair a Bluetooth
®
device with the PS3™ system, the Bluetooth
®
device becomes the default for both input and output audio. If the
headset is working correctly, you can hear your voice loopback in the headset. The audio input bar will indicate your voice level.
To Next Page
Loading...
