The Timer
19
GB
Before you set the clock, connect the power
source (see page 23).
1 Hold down CLOCK/SLEEP/TIMER
until “CLOCK” appears in the display.
The hour digit flashes.
2 Turn the jog dial to set the current hour.
Then press ENTER.
The minute digits flash. Set the minutes
by turning the jog dial until the correct
minute is displayed.
The Timer
Setting the clock
“– –:– –” indication appears in the display
until you set the clock.
3 Press ENTER.
The clock starts from 00 seconds.
Tip
The time display system:
CFD-E90: 12-hour system
CFD-E90L: 24-hour system
ENTER Jog dial
CLOCK/SLEEP/TIMER
To Next Page
Loading...
Need help?
General
