Sony CFS-W501L/S - Page 5

CFS-WS5O1L/S CFS-WS501L/S
For
SW
tuning
;
MEMORY
PRESET
TUNING
There are
7
SW
frequency
bands
(see
frequency
table).
Table of SW frequency bands Band Frequencies
In step 2 of MANUAL TUNING, if you press SW, the last :
49m 585—6.35 MHz *
To memorize a preset station
previously
tuned
SW-band
(eg.
31
m)
will
be
selected.
Each
41m
700—750
MHz
Ex.
To
memorize
89.20
MHz
FM
at
preset
2.
time
you
press
SW,
the
band
will
advance,
(to
25m,
19m...).
31m
9.40—990
MHz
:
First
the
meter
band,
then
the
frequency
will
be
displayed.
25m
41.60—12.10
MHz
PRESET
After
13
m,
the
49
m
band
is
selected.
19m
1510-1560
MHz
2
16m
—1755—-18.05
MHz
# RADIO
*
MHz
=
kHz»
1000
13m
21.40—21.90
MHz
Fin
iW)
Ws
Sw
MEMORY
iJ
Saat
aa
as
ED
at
ET
mete
FM/MW/LW/SW
PRESET
TUNING
Tune. Hold down MEMORY and press 2. 2 will appear.
ou
eS
PIE AA
U
Cetus Ls ae
Loar)
—_>
sw sw sw
aos )3 (cee cmmniiad Sumas 7am
; 2 To tune a preset station
: After memorizing in the example above: press FM, then
FM/MW/LW/SW (FM/MW/SW) PRESET TUNING 2.
Memorized station FM 89.20 MHz will be tuned.
FM 89.20 MHz is now memorized at preset 2.
AUTO SCAN TUNING
How many stations can be preset?
In step 3 of “MANUAL TUNING,” hold down + or — for Note on LW frequency display CFS-W501L: one FM, one MW, one SW and one LW station
several
seconds,
then
release.
LW
frequency
assignments
are
being
revised.
During
auto
for
each
FM/MW/LW/SW
PRESET
TUNING
button:
a
total
A tone will sound. tuning, frequency displays may be different from the actual of 20 preset stations.
The
tuner
will
tune
in
the
nearest
station
in
that
direction,
frequency
tuned.
Tuning
quality
is
not
affected.
CFS-W501S:
one
FM,
one
MW
and
one
SW
station
for
each
play for 5 seconds, then move to the next station in the FM/MW/SW PRESET TUNING button: a total of 15 preset
selected direction. This process will repeat. To eliminate noise when broadcast source is nearby stations.
When a station you want to listen to is tuned in, press Set SENS to LOCAL.
+ or — within 5 seconds. LW frequency revision
The tuner will remain tuned to that station. Graphic equalizer adjustments Due to a revision of LW frequency assignments, manual ad-
These are the frequency coverages of the equalizer controls. justments may be necessary after tuning of a preset station.
When you reach the first or last frequency in a band 100 Hz: bass.
An aiarm tone will sound. Press + or - to adjust the tuner 400 Hz: speaking voice, middle frequencies of instrumenial
in the opposite direction to stop the alarm. (Alarm will not music.
sound if a station is present at the first or last frequency.) 1 kHz: singing vocals. Boost for increased “presence.”
4kHz: overall brightness of sound.
If tuner stops at frequencies with no station 10 kHz: general treble. Lower to reduce noise. HOUSE CURRENT
This may occur when a broadcast source is nearby. If so, set Raise control to emphasize a frequency band, lower to
SENS to LOCAL. de-emphasize. AC power cord
AC IN socket
=
to a wall outlet
Antenna
adjustment
—
220v—240v
NOV— 120V
VOUTAGE
SELECTOR
(For CFS-W501S only) Adjust the VOLTAGE SELECTOR.
For customers supplied with an AC plug adaptor
Use adaptor if the plug of the AC power cord does not
match the outlet.
Note
The unit cannot be operated on the internal batteries (if
present) when the AC power cord is connected to the unit.
You must remove the AC power cord to use battery power.