Sony CPD-101VS - Picture Tube Removal

CPD-101VS
2-4
3 When one side of the rubber cap is
separated from the anode button, the
anode-cap can be removed by turning
up the rubber cap and pulling up it in
the direction of the arrow c.
• HOW TO HANDLE AN ANODE-CAP
1
Don’t hurt the surface of anode-caps with shartp shaped material!
2 Don’t press the rubber hardly not to hurt inside of anode-caps!
A material fitting called as shatter-hook terminal is built in the
rubber.
3 Don’t turn the foot of rubber over hardly!
The shatter-hook terminal will stick out or hurt the rubber.
a
b
Anode Button
c
• REMOVAL OF ANODE-CAP
NOTE: Short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or carbon painted on the CRT,
after removing the anode.
• REMOVING PROCEDURES
1 Turn up one side of the rubber cap in
the direction indicated by the arrow a.
2 Using a thumb pull up the rubber cap
firmly in the direction indicated by the
arrow b.
Cushion
3
Two screws
(+BVTP 4 x 16)
Tension spring
11
Demagnetization coil
10
Two claws
4
Stand block
5
8
Four screws
(Tapping screw 5)
Deflection yoke
7
Neck assy
6
A block
CN302
CN303
CN314
CN512
CN501
2P
CN601
2
Anode cap
1
Picture tube
9
Two degaussing coil holders
12
Two degaussing coil holders
13
2-6. PICTURE TUBE REMOVAL