1-4
DCU-8000 IM
Screws
(with drop-safe)
Screws
(with drop-safe)
1-4. Installing the Options
1-4-1. Installing the Plug-in Boards
n
Be sure to turn off the POWER switch before starting
installation work.
If installation work is started with the POWER switch left
on, it may cause electrical shock or damage to printed
circuit boards.
Installation
1. Turn off the main power of the MKS-8700 and
disconnect the AC power cord from the wall outlet.
2. Loosen the four screws (with drop-safe) and remove
the front panel in the direction of the arrow.
3. Remove the four screws (B3 x 5) and remove the
plug-in board loose-proof assembly.
4. While the eject levers are kept open as shown in the
illustration, insert the plug-in board into the board
guide rails.
Name of option Name of board
Slot on the front side
MKS-8701 RC-90 2, 3, 4, 5, 6
MKS-8702 IF-848 2, 3, 4, 5, 6
B3 x 5
B3 x 5
Plug-in board
loose-proof assembly
Eject levers
Plug-in board
To Next Page
Loading...
