40
For details on the operation
t
page 29
To cancel the protection
In single-image mode
Press z in step 3 or 4 of “To protect images in single-image mode.”
In index mode
1 Select the image for which you want to remove protection in step
5 of “To protect images in
index mode
.”
2 Press z to turn the - indicator gray.
3 Repeat the operation above for all images to be unprotected.
4 Press MENU, select [OK] with B, and then press z.
To cancel protection of all images in the folder
Select [All In This Folder] in step 4 of “To protect images in index mode,” and press z.
Select [Off] with
B, then press z.
• Note that formatting the recording media erases all the data stored on it, even if images are protected, and
these images cannot be recovered.
• It may take some time to protect an image.
Adds a (Print order) mark to images you want to print (page 73).
See page 70.
Plays back recorded images in order (Slide show).
Interval
DPOF
(Print)
(Slide)
3 sec
Sets the slide show interval.
5 sec
10 sec
30 sec
1 min
To Next Page
Loading...
