54
For details on the operation
t
page 45
Setup 2
2
The default settings are marked with .
Selects the method used to assign file numbers to images.
Selects the USB mode to be used when connecting the camera to a computer or a PictBridge
compliant printer using the cable for multi-use terminal (DSC-S90/S80/S60) or Cyber-shot
Station (DSC-ST80).
Sets the video signal output according to connected equipment.
File Number
Series
Assigns numbers to files in sequence even if the recording
folder or the “Memory Stick” is changed. (When the replaced
“Memory Stick” contains a file with a number higher than the
last assigned number, a number one higher than the largest
number is assigned.)
Reset
Starts from 0001 each time the folder is changed. (When the
recording folder contains a file, a number one higher than the
largest number is assigned.)
USB Connect
PictBridge
Connects the camera to a PictBridge compliant printer (page
70).
PTP
When [PTP] (Picture Transfer Protocol) is set and the camera
is connected to a computer, the images in the recording folder
selected by the camera are copied to the computer.
(Compatible with Windows XP and Mac OS X.)
Normal
Connects the camera to a computer (page 59).
Video Out
NTSC
Sets the video output signal to NTSC mode (e.g., for the
USA, Japan).
PAL
Sets the video output signal to PAL mode (e.g., for Europe).
To Next Page
Loading...
Need help?
General
