82
The image does not appear on the screen.
• If the cable for multi-use terminal is connected, disconnect it (page 75).
Your camera cannot delete an image.
• Cancel the protection (page 40).
• Set the write-protect switch on the “Memory Stick” to the recording position (page 91).
You have deleted an image by mistake.
• Once you have deleted an image, you cannot restore it. We recommend that you set protection
on an image (page 39), or set the write-protect switch on the “Memory Stick” to the LOCK
position (page 91) to prevent accidental erasure.
The resizing function does not work.
• You cannot resize movies and Multi Burst images.
You cannot display a DPOF (Print order) mark.
• You cannot display DPOF (Print order) marks on movies.
You cannot cut a movie.
• The movie is not long enough to cut (shorter than about two seconds).
• Cancel the protection (page 40).
• Still images cannot be cut.
You do not know if the OS of your computer is compatible with the camera.
• Check “Recommended computer environment” (page 57) for Windows, and “Recommended
environment” (page 67) for Macintosh.
You cannot install the USB driver.
• In Windows 2000, log on as Administrator (authorized Administrators) (page 58).
Your computer does not recognize your camera.
• Turn on the camera (t step 2 in “Read This First”).
• When the battery level is low, install the charged batteries, replace the batteries with new ones
(
t step 1 in “Read This First”), or use the AC Adaptor (not supplied) (page 15).
• Use the cable for multi-use terminal (DSC-S90/S80/S60) or Cyber-shot Station (DSC-ST80)
(page 59).
Deleting/Editing images
Computers
To Next Page
Loading...
Need help?
General
