To
change
the
date
and
time
See the
"User's
GuidelTroubleshooting" (page 122)
Select [Daterrime setup]
in
the
~
Setup menu and perform the procedure
in
step
$-2
to -5.
When
turning
on
the
power
Unless you set the clock, "Set date and time?" appears each time the camera
is
turned on.
To
turn
off
the
power
Set the POWER switch to OFF sliding
in
the arrow direction. Attach the lens cap. After you
remove the lens, store the camera with the body cap attached.
d
UD
OFFI
ION
POWER
Power
Save
(The
camera
nearly
shuts
down
if it
is
not
operated)
If you do not operate the camera for about five seconds, the recording mode display
on
the
LCD monitor disappears. Also,
if
you do not operate the camera for about three minutes, the
camera turns to power saving mode and nearly shuts down (Power Save).
To
cancel the power
save, operate the camera, for example,
by
pressing the shutter button halfway down.
• You can change the time that must elapse
to
activate the function (the default sellings are
[5
secJ/[3 min]).
-+
"User's GuidelTroubleshootillg" (page /20)
Changing the language setting
You can change the screen display
to
show messages
in
a specified language.
To
change the
language setting, follow the procedure below.
1 Press MENU to display the menu.
2 Select
[~
]
-+
[1] with
"'/~
on the multi-selector.
3 Select
[~
Language] with
~
on the multi-selector, then press the center
of
the multi-
selector. •
4 Select the desired language with
~
on the multi-selector, then press the center
of
the
multi-selector.
11
To Next Page
Loading...
