Sony DVS-2000C - Page 23

ee mas ill
Section 1 OPERATION
1-16
lEE RRDIRU RE
Section 1 OPERATION
i a Ae TS SUN Re EES FTN AL ee]
O~QesKeRTRS 7
$V
SRN
OW
FIRES
HIDE
L
ORULVOIRE
RL
E
FT. THENDIA YOSEF —-FRIVY FRAHENHSZE
Otc, RUTETATE RCA RORLED, SY TEM ISD
PFOEFIIMHEL TET,
:
® to @ Communication status indicators
Show the communication status of equipment connected to
the rear panel. These indicators alternately light and go out
when data and commands are input over the relevantlines.
The connectors and indicators are related as follows.
a) Bsé 0 BKDS-2072 RSE St4/ With optional BKDS-2072 installed
€@ FRAME MEMORY BOARD (7 Lb — 4.x © —2E4R)
eT
FROME CT.
@~@STATUSUR) RRS > TF
HUGO MMIC L ET
@ WAP Oy PMI KO—WA4 vF
D/AA DMF OAH ERRFY FMESET TUS ERI
BMTSLE, FTAyID/APUyYFHLIA bAL VFO
CHD OMA SET SOIL ET.
@® DWAPOVIRL IAT YF
D/AA DSF OAD ANE Y AMES ETI USES
BRT SL EGATS 7 Uy DERIRLET.
@ 44 vFOREARIN I THL < td, Maintenance Manual Part
1EZTHS KEW,
® inAnmF
SHA ECB CHEF Y 2 NTPMFILIV EVIL
THCOGL. FUR MBSEADLEF. COBSATH+
UPB sIBRSH, D/AMDMFOMSHAEHET.
Bik My Revere
Section 1 OPERATION
@ FRAME MEMORY BOARD connector
This connector is provided for future system expansion. .
® to @STATUS indicators
Used for manufacturing adjustments.
@ D/A clock phase control switch
Use this switch to adjust the phase of the clock (selected
with the D/A clock select switches @) which is used
when converting digital signals input to the D/A input
connector @ into analog signals.
@ D/A clock phase select switches
Select the clock phase used when converting digital
signals input to the D/A input connector @ into analog
signals.
For more information about setting these switches, refer to the
Maintenance Manual, Part I.
@® D/A input connector
Connect with a flexible cable to one of the digital TP
connectors on other circuit boards, and input a digital
signal. The digital signal is converted to an analog signal
and output from the D/A output connector @.