Sony DVS-2000C - Page 3

WARNING
To prevent fire or shock hazard, do not
expose the unit to rain or moisture.
To avoid electrical shock, do not open
the cabinet. Refer servicing to qualified
personnel only.
This symbol is intended to alert the
user to the presence of important
operating and maintenance
(servicing) instructions in the
literature accompanying the
appliance.
For the customers in the USA
This equipment has been tested and found to comply
with the limits for a Class A digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference when the equipment is operated in a
commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction
manual, may cause harmful interference to radio
communications. Operation of this equipment ina
residential
area
is
likely
to
cause
harmful
interference
in
which case the user will be required to correct the
interference at his own expense.
You are cautioned that any changes or modifications not
expressly approved in this manual could void your
authority to operate this equipment.
The shielded interface cable recommended in this
manual must be used with this equipment in order to
comply with the limits for a digital device pursuant to
Subpart B of Part 15 of FCC Rules.
WARNING
If
used
in
USA,
use
the
UL
LISTED
power
cord
specified
below.
DO
NOT
USE
ANY
OTHER
POWER
CORD.
Plug
Cap
Parallel
blade
with
ground
pin
(NEMA 5-15P Configuration)
Cord Type SJT, three 16 or 18 AWG wires
Length Less than 2.5 m (8 ft 3 in)
Rating Minimum 10 A, 125 V
Using
this
unit
at
a
voltage
other
than
120
V
may
require
the
use
of
a
different
line
cord
or
attachment
plug,
or
both.
To
reduce
the
risk
of
fire
or
electric
shock,
refer
servicing
to
qualified
service
personnel.
For the customers in Canada
This
apparatus
complies
with
the
Class
A
limits
for
radio
noise
emissions
set
out
in
Radio
Interference
Regulations.
Pour les utilisateurs au Canada
Cet
appareil
est
conforme
aux
normes
Classe
A
pour
_
bruits
radioélectriques,
spécifiés
dans.le
Reglement
sur
le
brouillage
radioélectrique.
VORSICHT
Um Feuergefahr und die Gefahr eines elektrischen
Schlages zu vermeiden, darf das Gerat weder Regen
noch Feuchtigkeit ausgesetzt werden.
Um einen elektrischen Schlag zu vermeiden, darf das
Gehduse nicht gedfinet werden. Uberlassen Sie
Wartungsarbeiten stets nur einem Fachmann.
Bescheinigung des Herstellers / Importeurs
Hiermit wird bescheinigt, daB die Digital-Video-
Schalteinheit DVS-2000C in Ubereinstimmung mit den
Bestimmungen der BMPT-Amisblatt Vig 243/1991 und
Vig 46/1992 funkentstért ist. Der vorschriftsmaBige
Betrieb mancher Gerate (z.B. MeBsender) kann
allerdings gewissen Einschrankungen unterliegen.
Beachten Sie deshalb die Hinweise inder
Bedienungsanleitung. Dem Bundesamt fiir Zulassungen
in der Telekommunikation wurde das Inverkehrbringen
dieses Gerates angezeigt und die Berechtigung zur
Uberpriifung der Serie auf die Einhaltung der -
Bestimmungen eingeraumt.
Sony Deutschland GmbH
Hugo Eckener Str. 20
50829 KSIn
Hinweis
Gema8 der Amtsbiatter des BMPT Nrn. 61/1991 und 6/
1992 wird der Betreiber darauf aufmerksam gemacht,
da die von ihm mit diesem Geradt zusammengestelite
Anlage auch den technischen Bestimmungen dieser
Amtsblatter genigen mu8.
For the customers in the United Kingdom
WARNING
THIS APPARATUS MUST BE EARTHED
IMPORTANT
The wires in this mains lead are coloured in
accordance with the following code:
Green-and-yellow: Earth
Blue: Neutral
Brown: Live
As the colours of the wires in the mains lead of this
apparatus may not correspond with the coloured
markings identifying the terminals in your plug proceed
as follows:
The wire which is coloured green-and-yellow must be
connected to the terminal in the plug which is marked
by the letter E or by the safety earth symbol or
coloured green or green-and-yeliow.
The wire which is coloured blue must be connected to
the termina! which is marked with the letter N or
coloured black.
The wire which is coloured brown must be connected
to the terminal which is marked with the letter L or
coloured red.