Sony DVS-2000C - Page 71

PACH, FEC Litto tT BEBEt FOTO FS
Wi,
PL VBR Se LILOWMT CBRL EE ECMRETVE
Fo
) Bt-v hOB LRENT.
ii) PBR ORME IA NEBLAA, BATS A4 oF
VIFVE2V—-FORERBRV 2-AtHs, FV
VBEHTASSS, MESBESBONZEC, WE
tS.
jEz
RRB OReI, BATSSTOA— FERERBALER
RECT Oo T < Aa rs Wo
Bade BS IN
Adjustment Driver
If the specification is not satisfied, adjust the voltage as
described below.
The voltage adjustment is performed with the digital voltmeter
connected to the above test connector.
i) Remove the blind plate of the power unit.
i) Insert the tip of an adjustment driver from the adjustment
window and tum the voltage adjustment potentiometer of
the corresponding switching regulator. Adjust the
potentiometer until the digital voltmeter reads a proper
voltage.
Set the power supply voltage with all the card boards to be
used inserted.
”
-
screw (BVTT3x5) © Bp ¢ Lif
Blind Plate
2-20
DVS-2000C