Note
When you are finished with using the receiver and the microphone, select “OFF” with the slide switch on the receiver and press
and hold the
(power) button on the microphone for about 2 seconds to turn off this unit.
Depending on the using condition, an analog connection with this unit may cause noises to be included in audio recordings.
To use a camera compatible with the digital audio interface of the Multi Interface Shoe or a device with a USB audio input
capability, make a digital connection with this unit. When a radio device is nearby, keep this unit sufficiently away from the device.
While video recording is in progress, operating the filter switch, the directivity selection switch, or the AUDIO LEVEL dial on the
microphone may cause operation sounds to be included in the recording. Before changing the switch/dial settings, be sure to
stop the recording.
When a video recording is made with this unit, an operation sound (an electronic sound) may be included at the beginning of the
recording. It is recommended that you disable the operation sound settings on your camera before making video recordings. For
details, refer to the operating instructions of your camera.
The receiver receives power supply from the camera as well. (The built-in battery of the receiver, however, is not charged with the
supplied power.) Depending on your camera, however, it may not be capable of supplying power. For the camera models that
support power supply to the receiver, visit our website at:
https://www.sony.net/dics/ecms1/
Related Topic
Lamp indications
5-054-814-11(1) Copyright 2023 Sony Corporation
Before recording, make sure that the surface of the microphone with the (power) button faces to the sound
source.
Adjust the recording volume level by turning the AUDIO LEVEL dial while monitoring the indicator lamps, or adjust
the distance between the audio source and the microphone.
In the event that sounds are picked at the normal volume level: Adjust the recording volume level so that none
of the indicator lamps would light in orange.
In the event that sounds are picked at an extremely loud volume level: Adjust the recording volume level so that
the top indicator lamp would not light in red.
To Next Page
Loading...
Need help?
General
