Help Guide
Wireless Microphone
ECM-W2BT
Charging the receiver
Connect the receiver to a computer to charge the receiver's built-in battery.
Note
While charging the battery, keep the receiver turned off. Turning on the receiver while charging makes the receiver ready for
power supply and stops charging.
Do not apply force to the receiver when you connect the receiver to a computer. This may cause damage to the receiver or the
computer.
When you connect the receiver to a notebook computer that is not connected to an AC power source, the battery of the notebook
computer may be depleted rapidly. Do not leave the receiver connected to the computer for a long time.
Charging the battery or the connection with customized or hand-built computers is not guaranteed. Depending on the type of
USB device used, charging may not function properly.
Operation with all computers is not assured.
Related Topic
Lamp indications
Turn off the receiver.
Charging is not possible when the receiver is turned on.
1
Open the connector cover, connect the receiver to an activated computer with the supplied micro USB
cable.
The power lamp lights in orange.
Connector cover
Micro USB cable
Power lamp
2
When charging is finished, disconnect the micro USB cable between the receiver and the computer.
Wait until the power lamp goes out to indicate that charging is finished (the battery is fully charged).
3
To Next Page
Loading...
Need help?
General
