Need help?Do you have a question about the Sony EV-C3E and is the answer not in the manual?
General| Video Head | 2 heads |
|---|---|
| Audio | Mono |
| TV System | PAL |
| Recording System | Rotary 2-head helical scan system |
| Power Source | AC 50/60 Hz |
| Input/Output | RF output |
| Microphone Input | 3.5mm mini jack |
| Remote Control | Yes |
Highlights critical safety components for replacement.
Provides instructions for repairing flexible circuit boards.
Offers notes on replacing chip components, especially tantalum capacitors.
Covers tape pass adjustment and track shift mode settings.
Details preparation, power checks, system, servo, video, and audio adjustments.
Provides steps to eject a stuck videocassette.
Outlines procedures for cleaning the video head and transport system.
Details the procedure for replacing the rotating drum, including precautions.
Provides essential safety instructions to prevent hazards.
Details the functions of buttons on the remote commander.
Details tape transport and special function buttons on the remote.
Details how to set the track shift mode for fine adjustment.
Lists alignment tapes and specifies signal checks for video and audio.
Details procedures for confirming power supply voltages.
Details adjustments for oscillation frequency and switching position.
Details CH1, CH2, and CH1' adjustment for frequency characteristics.
Details checks for crystal oscillator and SYNC AGC.
Guides the adjustment for Y/C separation.
Details adjustments for burst frag and emphasis.
Guides the adjustment for PB CCD input level.
Covers PB Y level and Y FM carrier frequency adjustments.
Guides the adjustment for Y FM deviation.
Details AC clip check and chroma emphasis adjustment.
Guides REC Y and REC C level adjustments.
Details quasi and delay burst phase adjustments.
Details the AFM carrier frequency adjustment.
Guides PB level and E-E output level checks.
Covers overall level and frequency characteristics checks.
Details overall distortion and noise level checks.
To Next Page
