Sony F3216 - Page 49

To share your mobile connection by One-touch tethering
1
Make sure that both devices have the NFC function turned on, and that both
screens are active.
2
From your Home screen, tap .
3
Find and tap Settings > More > Tethering & portable hotspot.
4
Tap the Portable hotspot slider to enable the function.
5
Tap One-touch portable hotspot. Hold the devices together so that the NFC
detection areas of each device touch, then tap CONNECT.
This function only works with devices that also support NFC Wi-Fi tethering.
To share your mobile data connection with another Bluetooth® device
1
Make sure that your device and the other Bluetooth® device are paired with
each other and that mobile data traffic is activated on your device.
2
Your device: From your Home screen, tap
.
3
Find and tap Settings > More > Tethering & portable hotspot and then tap the
Bluetooth tethering slider to enable the function.
4
Bluetooth® device: Set up the device so that it obtains its network connection
using Bluetooth®. If the device is a computer, refer to the relevant instructions
to complete the setup. If the device runs on the Android™ operating system,
tap the settings icon beside the name of the device that it is paired with under
Settings > Bluetooth > Paired devices, then mark the Internet access checkbox.
5
Your device: Wait for
to appear in the status bar. Once it appears, the setup
is complete.
6
Tap the Bluetooth tethering slider again to disable the function.
The
Bluetooth tethering function is turned off every time you turn off your device or turn off the
Bluetooth® function.
To use your device as a portable Wi-Fi hotspot
1
From your Home screen, tap .
2
Find and tap Settings > More > Tethering & portable hotspot.
3
Tap Portable hotspot settings > Configure hotspot.
4
Enter the Network name (SSID) information.
5
To select a security type, tap the Security field. If required, enter a password.
6
Tap SAVE.
7
Tap , then tap the Portable hotspot slider to enable the function.
8
If prompted, tap OK to confirm. appears in the status bar once the portable
Wi-Fi hotspot is active.
To allow a WPS-supported device to use your mobile data connection
1
Make sure that your device is functioning as a portable hotspot.
2
From your Home screen, tap .
3
Find and tap Settings > More > Tethering & portable hotspot > Portable hotspot
settings.
4
Under Configure hotspot, make sure that your portable hotspot is secured by a
password.
5
Enable Discoverable, if it was disabled.
6
Tap WPS Push Button, then follow the relevant instructions. Alternatively, tap
> WPS PIN Entry, then enter the PIN that appears on the WPS-supported
device.
To rename or secure your Mobile Hotspot
1
From the Home screen, tap .
2
Find and tap Settings > More > Tethering & portable hotspot.
3
Tap Portable hotspot settings > Configure hotspot.
4
Enter the Network name (SSID) information.
5
To select a security type, tap the Security field.
6
If required, enter a password.
7
Tap SAVE.
49
This is an Internet version of this publication. © Print only for private use.