masterpage:Right
filename[G:\_Upload\3073074111\307307411MVCFD100UC\02GB-
MVCFD100UC\09add.fm]
89
model name1[MVC-FD100/200]
[3-073-074-11(1)]
Additional information
You cannot display a print
mark.
• You cannot display print marks on moving images,
text images and Clip Motion images.
The picture is noisy. • Your camera is placed near a TV or other
equipment that uses strong magnets.
t
Move your camera away from the TV, etc.
The picture is too dark. • You are shooting a subject with a light source
behind the subject.
t
Adjust the exposure (page 67).
• The brightness of the LCD screen is too low.
t
Adjust the brightness of the LCD screen
(page 20).
The flash does not work. • The flash is set to .
t
Set the flash to (no indication), , or
(page 22).
• The camera is in one of the following PROGRAM
AE modes: Twilight, Twilight plus, or Landscape.
t
Cancel the PROGRAM AE function or set the
flash to (pages 22, 65).
• The PLAY/STILL/MOVIE selector is set to
MOVIE.
t
Set it to STILL.
The date and time are
recorded incorrectly.
• The date and time are not set correctly.
t
Set the correct date and time (page 14).
Vertical streaks appear
when you are shooting a
very bright subject.
• This is called the smear phenomenon.
t
This is not a malfunction.
The zoom does not work. • PROGRAM AE is set to the Panfocus mode.
t
Cancel the Panfocus mode (page 65).
Digital zoom does not
work.
• You cannot use digital zoom when recording
moving pictures.
• Digital zoom is set to [OFF].
t
Set digital zoom to [ON] at the menu.
The image is in
monochrome.
• You shot the image in TEXT mode.
t
Cancel the TEXT mode (page 62).
• The picture effect is set to B&W.
t
Cancel the B&W mode (page 69).
The image cannot be
played back on a
computer.
t
Consult the computer or software manufacturer.
Symptom Cause and/or Solution
01cov.book Page 89 Thursday, November 29, 2001 1:20 PM
To Next Page
Loading...
