Sony HBD-T57 User Manual (English)

To Next Page

SERVICE MANUAL

Sony Corporation

Audio&Video Business Group

Published by Sony Techno Create Corporation

HBD-E370/E470/

E570/E870/T57

SPECIFICATIONS

BLU-RAY DISC/DVD RECEIVER

9-889-770-01

2010B05-1

2010.02

US Model

HBD-E370/E570/T57

Canadian Model

HBD-E370/E470/E870

AEP Model

UK Model

HBD-E370/E870

Ver. 1.0 2010.02

• HBD-E370 is the ampliﬁ er, video, BD/DVD/Super Audio CD/CD

system, USB, LAN and tuner section in BDV-E370.

• HBD-E470 is the ampliﬁ er, video, BD/DVD/Super Audio CD/CD

system, USB, LAN and tuner section in BDV-E470.

• HBD-E570 is the ampliﬁ er, video, BD/DVD/Super Audio CD/CD

system, USB, LAN and tuner section in BDV-E570.

• HBD-E870 is the ampliﬁ er, video, BD/DVD/Super Audio CD/CD

system, USB, LAN and tuner section in BDV-E870.

• HBD-T57 is the ampliﬁ er, video, BD/DVD/Super Audio CD/CD

system, USB, LAN and tuner section in BDV-T57.

Model Name Using Similar Mechanism BDP-S370

Mechanism Type BPX-5

Optical Pick-up Block Name KEM-460AAA

Photo: HBD-E370

Amplifier Section

U.S. models:

POWER OUTPUT AND TOTAL HARMONIC

DISTORTION:

(FTC)

Front L + Front R: With 3 ohms loads, both

channels driven, from 180

- 20,000 Hz; rated 60 watts

per channel minimum

RMS power, with no more

than 1% total harmonic

distortion from 250 milli

watts to rated output.

Other models:

POWER OUTPUT (rated)

Front L/Front R: 108 W + 108 W (at 3 ohms,

1 kHz, 1% THD)

HBD-E370:

POWER OUTPUT (reference)

Front L/Front R/Center/Surround L/Surround R:

142 W (per channel at 3

ohms, 1 kHz)

Subwoofer: 140 W (at 3 ohms, 80 Hz)

HBD-E870/HBD-E570/HBD-E470/HBD-T57:

POWER OUTPUT (reference)

Front L/Front R/Center/Surround L/Surround R:

167 W (per channel at 3

ohms, 1 kHz)

Subwoofer: 165 W (at 3 ohms, 80 Hz)

Inputs (Analog)

AUDIO (AUDIO IN) Sensitivity: 450/250 mV

Inputs (Digital)

SAT/CABLE (COAXIAL), TV (OPTICAL)

Supported formats: LPCM

2CH (up to 48 kHz), Dolby

Digital, DTS

Video Section

Outputs VIDEO: 1 Vp-p 75 ohms

COMPONENT:

Y: 1 Vp-p 75 ohms

PB/CB, PR/CR: 0.7 Vp-p

75 ohms

HDMI OUT: Type A (19

pin)

BD/DVD/Super Audio CD/CD System

Signal format system NTSC (US and

USB Section

(USB) port: Type A (For connecting

USB memory, memory

card reader, digital still

camera, and digital video

camera)

Maximum current: 500 mA

LAN Section

LAN (100) terminal 100BASE-TX Terminal

Tuner Section

System PLL quartz-locked digital

synthesizer

FM tuner section

Tuning range

North American models: 87.5 MHz - 108.0 MHz

(100 kHz step)

Other models: 87.5 MHz - 108.0 MHz

(50 kHz step)

Antenna (aerial) FM wire ante

nna (aerial)

Antenna (aerial) terminals 75 ohms, unbalanced

Intermediate frequency 10.7 MHz

General

Power requirements

North American model:

120 V AC, 60 Hz

Other models:

50/60 Hz

Power consumption On: 170 W

Standby: 0.3 W (at the

Power Saving mode)

Dimensions (approx.) 430 mm × 85 mm × 335

mm (17 in × 3

/8 in ×

/4 in) (w/h/d) incl.

projecting parts

Mass (approx.) 4.8 kg (10 lb 10 oz)

Design and specifications are subject to change

without notice.

Canadian models)

PAL/NTSC (AEP and

UK models)

220 - 240 V AC,

TEL 13942296513 QQ 376315150 892498299

http://www.xiaoyu163.com

Need help?

Do you have a question about the Sony HBD-T57 and is the answer not in the manual?

Sony HBD-T57 Specifications

General

Brand	Sony
Model	HBD-T57
Category	Receiver
Language	English

Summary

SPECIFICATIONS

SECTION 1 SERVICING NOTES

Handling Optical Pick-up Block

Precautions for handling the optical pick-up block and its flexible boards.

Laser Diode Emission Check

Procedure for safe laser diode emission check, observing safety distance.

Unleaded Solder Information

Information about unleaded solder characteristics and usage.

Lead Free Mark Explanation

Explanation of the lead free solder mark.

Disc Tray Lock Release

Procedure to release the disc tray lock.

Lens Cleaning Caution

Warning against improper lens cleaning methods.

MB-134 Board IC Replacement Notes

Specific IC replacement advice for MB-134 board; exchange entire board if damaged.

CAPACITOR ELECTRICAL DISCHARGE PROCESSING

NOTE OF REPLACING THE OPTICAL DEVICE (KEM-460AAA) OR MB-134 BOARD

2. Pass-fail judgment of the optical device (KEM-460AAA)

2-1. Flow of drive section check

Flowchart for diagnosing drive section issues.

2-2. Flow of optical device IOP check

Flowchart for checking optical device IOP.

3. Optical device (KEM-460AAA) replacement

NOTE THE BD DRIVE (BPX-5) PARTS REPLACING

NOTE OF REPLACING THE THE IC3100, IC3200 AND IC3400 ON THE MAIN BOARD AND THE COMPLETE MAIN BOARD

MODEL IDENTIFICATION – Rear Chassis –

NOTE OF REPLACING THE D913, D931, IC901 AND IC921 ON THE POWER BOARD AND THE COMPLETE POWER BOARD

HOW TO OPEN THE TRAY WHEN POWER SWITCH TURN OFF

PROCESSING OF HARNESS (USB)

SECTION 2 DISASSEMBLY

2-1. DISASSEMBLY FLOW

Step-by-step procedure for disassembling the unit.

2-2. CASE (EZ)

Procedure for removing the outer case.

2-3. MB-134 BOARD

2-4. BRACKET (MB) BLOCK

2-5. FUSE (F901), POWER BOARD

2-6. FRONT PANEL BLOCK

2-7. CONNECT BOARD

2-8. BD DRIVE (BPX-5)

2-9. BACK PANEL BLOCK

2-10. MAIN BOARD

2-11. AUDIO BOARD

2-12. OPTICAL DEVICE (KEM-460AAA), WIRE (FLAT TYPE)

SECTION 3 TEST MODE

COLD RESET

Clears RAM data except BD/DVD data, returning set to initial conditions.

DEMO MODE

Locks disc tray, preventing ejection; displays 'LOCKED'.

S-AIR ID SETTING CHANGE

Procedure to change S-AIR ID settings.

PANEL TEST

Tests indicator tube segments and displays model information.

AMP TEST

Tests amplifier section and D.C.A.C. microphone status.

BD SERVICE MODE

Enters BD service mode for error log, diagnostics, and factory initialization.

2. Menu Tree

3. Service Mode Menu (Top Menu)

4. Diag (Device Test)

Tests mounted devices, including USB media check.

5. Diag (Video/Audio Test)

Performs video tests (color bar) and audio tests (tone sound).

6. Diag (Audio Input Test)

7. Diag (Wireless LAN Test)

8. Log: Error Log (Output of each Log)

9. Factory Initialize (Factory Settings)

10. Network (Network Test Diagnosis Screen: Ifconfi g)

11. Network (Network Test Diagnosis Screen: Ping)

12. System Information (System Information Display)

13. Drive

Screen 1: Selecting items under *Service Menu

Top menu for selecting service functions.

Screen 2: Selecting items under *Drive

Sub-menu for drive-related diagnostic and tool operations.

Screen 3: *Drive OP data Write

Writes OP data into flash IC; requires USB storage device.

Screen 4: *Servo Parameter Check Menu (Not Used)

Menu for checking servo parameters, noted as not used.

Screen 5: *Servo Signal Check Menu (Not Used)

Menu for servo signal monitoring, noted as not used.

Screen 6: *S-Curve Check Menu (Not Used)

Screen 7: *Readability Check Menu (Not Used)

Screen 8: *OP Position Check Menu (Not Used)

Screen 9: *OP Check Menu

Screen 10: *Load Eject Aging (Not Used)

Screen 11: *Spindle Control Check Menu (Not Used)

Screen 12: *FA Mode Test (Not Used)

CONFIRMATION ITEM

1. Playback Operation Confirmation

Confirms playback operation using test discs.

2. Networking Confirmation

Confirms network connection via LAN cable and router.

SECTION 4 ELECTRICAL CHECK

FM TUNER LEVEL CHECK

SECTION 5 DIAGRAMS

5-1. BLOCK DIAGRAM - SERVO Section -

Block diagram illustrating the servo section circuitry.

5-2. BLOCK DIAGRAM - MEMORY Section -

5-3. BLOCK DIAGRAM - TUNER, S-AIR Section -

5-4. BLOCK DIAGRAM - AUDIO Section -

5-5. BLOCK DIAGRAM - REGULATOR Section -

5-6. BLOCK DIAGRAM - PANEL, POWER SUPPLY Section -

5-7. SCHEMATIC DIAGRAM - MB-134 Board (1/13)

5-8. SCHEMATIC DIAGRAM - MB-134 Board (2/13)

5-9. SCHEMATIC DIAGRAM - MB-134 Board (3/13)

5-10. SCHEMATIC DIAGRAM - MB-134 Board (4/13)

5-11. SCHEMATIC DIAGRAM - MB-134 Board (5/13)

5-12. SCHEMATIC DIAGRAM - MB-134 Board (6/13)

5-13. SCHEMATIC DIAGRAM - MB-134 Board (7/13)

5-14. SCHEMATIC DIAGRAM - MB-134 Board (8/13)

5-15. SCHEMATIC DIAGRAM - MB-134 Board (9/13)

5-16. SCHEMATIC DIAGRAM - MB-134 Board (10/13)

5-17. SCHEMATIC DIAGRAM - MB-134 Board (11/13)

5-18. SCHEMATIC DIAGRAM - MB-134 Board (12/13)

5-19. SCHEMATIC DIAGRAM - MB-134 Board (13/13)

5-20. PRINTED WIRING BOARD - MB-134 Board (Component Side)

5-21. PRINTED WIRING BOARD - MB-134 Board (Conductor Side)

5-22. PRINTED WIRING BOARD - AUDIO Board -

5-23. SCHEMATIC DIAGRAM - AUDIO Board -

5-24. PRINTED WIRING BOARD - MAIN Board (Component Side)

5-25. PRINTED WIRING BOARD - MAIN Board (Conductor Side)

5-26. SCHEMATIC DIAGRAM - MAIN Board (1/5)

5-27. SCHEMATIC DIAGRAM - MAIN Board (2/5)

5-28. SCHEMATIC DIAGRAM - MAIN Board (3/5)

5-29. SCHEMATIC DIAGRAM - MAIN Board (4/5)

5-30. SCHEMATIC DIAGRAM - MAIN Board (5/5)

5-31. PRINTED WIRING BOARD - CONNECT Board -

5-32. SCHEMATIC DIAGRAM - CONNECT Board -

5-34. SCHEMATIC DIAGRAM - REG Board -

5-35. PRINTED WIRING BOARD - FL Board -

5-36. SCHEMATIC DIAGRAM - FL Board -

5-37. PRINTED WIRING BOARD - POWER Board -

5-38. SCHEMATIC DIAGRAM - POWER Board -

5-39. PRINTED WIRING BOARDS - KEY Section -

5-40. SCHEMATIC DIAGRAM - KEY Section -