Sony HCD-H77 - Page 9

A total of 30 stations can be stored in any
desired sequence, so that you can tune in
the stored station directly by entering the
memory page and number.
Storing Stations
1 Tune in the desired station.
2 Press MEMORY.
WisMI@ER@ appears tor several second.
3 While (EMWOGN is on, press SHIFT
to select the memory page (A, B or
C).
The memory pages (A, B or C) can be
classified according to the music
category, station band, etc.
4 White is on, press
PRESET/TIMER + or — to select the
| number (1 to 10).
| 5 Press ENTER.
disappears, and the station
is stored.
6 Repeat 1 to 5 for each stations to be
stored.
If you cannot store a station successfully
Press MEMORY again so that
appears, and then proceed with the steps 3
to 5 above.
Be sure to operate while
(approx. 4 seconds.)
Pimim@imag is on
When you have selected the wrong page
and number
Press MEMORY and then proceed with the
above steps.
TUNING
2
“6
3
—e
4
— PRESETTIMER—
=
5
To Tune in a Preset Station
1 Press SHIFT to select the memory
page.
2 Press PRESET/TIMER + or — to select
the desired number.
To select the number directly (remote
commander only) [J (HCD-H70/H77/H1400)
1 Set the CD/TUNER selector to TUNER.
2 Press SHIFT and the numeric button.
Indicator on the display
TUNED: Appears when a station of
sufficient signal strength is tuned
in.
STEREO: Appears when an FM stereo
program of sufficient signal
Strength is received.
Antenna adjustment [Ej
For FM reception, adjust the length and
direction of the telescopic antenna
(HCD-H66/H70/H77)
For MW, LW, and SW reception, find the
best location of the AM loop antenna.
Can a previously stored station be
erased?
No. Erasing only is not possible, but storing
a new Station erases the previous one.
important
The stored stations remain for
approximately 1 week even if no power is
supplied (e.g. the power cord is
disconnected, etc.). If they are erased,
store the stations again.
Al (HCD-H70/H77/H1400)
<=
OQ
<=
fe)
(2)
om
=<
~l
(=)
~
<=
~“
“J
_
<=
-=
3
(=)
~—s
=
-_=
i
(>)
Co)