32
Menu List
<'!' IND> 02
(U04)
ND [IND] ON ON, OFF [IND]: Set whether to be
included in the status
indications on the
viewfinder (see page 24).
[NORMAL]: Specify the
conditions under which the
‘!’ indication is not to be
displayed even if [IND] is
ON. (By specifying the
standard or normal
conditions here, non-
standard or abnormal
conditions can be found
with the ‘!’ indication on the
viewfinder.)
e.g.: With the default setting of
ND, the ‘!’ indication is
displayed when an ND filter
other than 1 is selected.
- - - : When CCU connected
(cannot be changed)
[NORMAL] 1 – – – – 1, 2, 3, 4, 5 (combination
allowed)
WHITE [IND] ON ON, OFF, - - -
[NORMAL] – A B P, A, B (combination allowed)
5600K [IND] ON ON, OFF, - - -
[NORMAL] OFF ON, OFF
GAIN [IND] ON ON, OFF, - - -
[NORMAL] – – L L, M, H (combination
allowed)
SHUTT [IND] ON ON, OFF, - - -
[NORMAL] OFF ON, OFF
FAN [IND] ON ON, OFF
[NORMAL] AUTO1 AUTO1, AUTO2, MIN, MAX
EXT [IND] ON ON, OFF
<VF MARKER> 03
(U05)
MARKER ON ON, OFF Except MASK
CENTER OFF ON, OFF
1 1, 2, 3, 4 1: Entire cross
2: Entire cross with a hole
3: Center
4: Center with a hole
SAFETY ZONE OFF ON, OFF
90.0% 80.0, 90.0, 92.5, 95.0%
EFFECT OFF ON, OFF
ASPECT OFF ON, OFF
4:3 16:9, 15:9, 14:9, 13:9, 4:3,
(4.3)
(4.3): If VF SCAN is set to 4:3
on HDLA attached (cannot
be changed)
MASK OFF ON, OFF, (ON) (ON): If VF SCAN is set to 4:3
on HDLA attached (cannot
be changed)
12 0 to 15 Set the level to darken
outside the aspect area.
SAFETY OFF ON, OFF For the safety marker in
Aspect mode
90.0% 80.0, 90.0, 92.5, 95.0%
<VF DETAIL> 04
(U02)
VF DETAIL ON ON, OFF
LEVEL 25% 0 to 100%
CRISP 0 –99 to +99
FREQUENCY 9M 9M, 14M, 18M
<ZEBRA> 05
(U07)
ZEBRA OFF ON, OFF
1 1, 2, 1&2
ZEBRA1 LEVEL 70% 50 to 109%
WIDTH 10% 0 to 30%
ZEBRA2 100% 50 to 109%
Page title No. Item Default Settings Remarks
To Next Page
Loading...
