Chapter 9 Function Menu
Chapter 9 Function Menu 9-5
Page 2
Item Setting
F1 (V.PROC) Selects the control method for the internal digital video processor.
LOCAL: Change the settings of the internal digital video processor by using this function menu.
REMOTE: Use the optional BVR-50/50P Remote Control Unit to control the internal digital video
processor.
MENU: Change the settings of the internal digital video processor by using F5 (MENU) of the HOME page.
Notes
When controlling the unit from the HKDV-503/900, set this item to MENU.
F2 (VIDEO) Sets the HD/SD video signal output level (–∞ to +3 dB).
PRESET: Regardless of manually set values, the video signal is set to the standard level.
Manual setting: With the displayed setting flashing, you can rotate the MULTI CONTROL knob to adjust
the value for the video signal output level.
F3 (CHROMA) Sets the HD/SD chroma signal output level (–∞ to +3 dB).
PRESET: Regardless of manually set values, the chroma signal is set to the standard level.
Manual setting: With the displayed setting flashing, you can rotate the MULTI CONTROL knob to adjust
the value for the chroma signal output level.
F4 (HUE)
(59.94i, 29.97PsF
mode)/(C PHAS)
(50i, 25PsF
mode)
Sets the color phase (phase relative to burst)
PRESET: Regardless of manually set values, sets the color phase to the standard value.
Manual setting: With the displayed setting flashing, you can rotate the MULTI CONTROL knob to adjust
the value across the range ±30°.
F5 (SETUP)
(59.94i, 29.97PsF
mode)/(BLACK)
(50i, 25PsF
mode)
Sets the setup level (59.94i, 29.97PsF mode) or black level (50i, 25PsF mode)
PRESET: Regardless of manually set values, the level is set to the standard value.
Manual setting: With the displayed setting flashing, you can rotate the MULTI CONTROL knob to adjust
the setup level across the range ±30 IRE (59.94i, 29.97PsF mode) or to adjust the black level across
the range ±210 mV (50i, 25PsF mode).
F6 (YC DLY) Sets amount of Y/C delay for playback of analog Betacam tapes.
PRESET : Regardless of manually set values, the Y/C delay is set to the standard value.
Manual setting: With the displayed setting flashing, you can rotate the MULTI CONTROL knob to adjust
the Y/C delay across the range ±100 ns.
To Next Page
Loading...
