30
GB
Listening to the Device
Connected with an
Analog Audio Cable
You can listen to sound of an audio
device such as a WALKMAN®, etc. that is
connected to the ANALOG IN jack on the
bar speaker.
1 Connect an audio device to the
ANALOG IN jack.
2 Press HOME.
The home menu appears on the TV
screen.
3 Select [Listen] - [Analog] on the
home menu.
The [Analog] screen is displayed on
the TV screen.
4 Start audio playback on the
connected audio device.
Sound is output from the speaker
system.
5 Adjust the volume (page 35).
Tip
You can also select [Analog] directly by
pressing ANALOG on the remote control.
Listening to Sound of the
Connected TV or Device
Using Headphones
1 Set the BLUETOOTH compatible
headphones to pairing mode.
Refer to the operating instructions
of the headphones for the pairing
method.
2 Press HOME.
The home menu appears on the TV
screen.
3 Select [Setup] - [Advanced
Settings] on the home menu.
4 Select [Bluetooth Settings] -
[Bluetooth Mode] - [Transmitter].
The speaker system enters
BLUETOOTH transmission mode.
5 Select the name of the
headphones from the [Device List]
in [Bluetooth Settings].
When the BLUETOOTH connection is
established, [Connected] appears.
If you cannot find the name of your
headphones in [Device List], select
[Scan].
6 Return to the home menu, select
[Watch] or [Listen], and
select the input.
The image of the selected input
appears on the TV screen, [BT TX]
appears in the front panel display,
then the sound is output from the
headphones.
Sound from the speaker system is
muted at the same time.
Smartphone,
WALKMAN®, other
audio devices, etc.
Analog audio cable
(not supplied)
Listening to Sound by Pairing
with Headphones
To Next Page
Loading...
