3 Select the
input
of
the system
connected
to
the
component
you
want
to
watch
(80,
OVO,
SAT), and
switch
the HOMI
input
of
the TV,
so
that
an
image from the connected
component
is
displayed.
4 Set the Control
for
HOMI
function
of
the
TV
to
on.
The Control for HOMI function for the
system and the connected component
is
simultaneously set to on.
Ouring the setting, "SCANNING" appears
in the front panel display. After you finish
the setting, "COMPLETE" appears in the
front panel display. Wait until the setting
is
complete.
If
"SCANNING"
or
"COMPLETE"
does
not
appear
after
performing
the
steps
above
Set the Control for HOMI function to on for the
system and the connected component
individually.
1 Press AMP MENU.
2 Press
~/1'
repeatedly
until
"SET HOMI"
appears, then press
c:B
or~.
3 Press
~/1'
repeatedly
until
"CTRL:
HOMI" appears, then press
c:B
or~.
4 Press
~/1'
to
select "ON."
5 Press AMP MENU.
The AMP menu turns off. The Control for
HOMI function is set to on.
6 Set the Control
for
HOMI
function
of
the
connected
component
to
on.
For details on setting the connected
component, refer to its operating
instructions.
7 Select the
input
of
the system
connected
to
the
component
you
want
to
use the Control
for
HOMI
function
for
(80,
OVO,
SAT), and repeat step
6.
22
US
If
you
add
or
reconnect
the
component
Perform steps
of
"Preparing for the
"BRA
VIA"
Sync" and
"If
"SCANNING" or "COMPLETE"
does not appear after performing the steps
above" again.
• During the setting
of
the Control for HOMI function
for the system, the System Audio Control function
does not work.
•
If
the Control for HOMI function for the connected
component cannot be set simultaneously by setting
"CONTROL FOR HOMI"
of
the TV, set the Control
for HOMI function using the menu
of
the connected
component.
• For details on setting the TV and the connected
components, refer to their operating instructions.
• The default setting
of
the Control for HOMI function
of
the system is "OFF."
To Next Page
Loading...
