83
GB
Additional Information
Clearing the receiver’s memory may remedy
the problem (page 32). However, note that all
memorized settings will be reset to their initial
settings and you will have to readjust all
settings on the receiver.
Consult your nearest Sony dealer. Note that if
service personnel changes some parts during
repair, these parts may be retained.
Specifications
Amplifier section
Models of area code AU, E51, SA, EA, CA
• Receiver (STR-KM7500)
Power Output
Stereo mode output (rated) (6 ohms, 1 kHz,
THD 1%)
100 W + 100 W
1)
Surround mode output (reference)
2)
RMS output
FRONT: 185 W per channel
1)
(with SS-MSP7500)
CENTER: 185 W
1)
(with SS-CNP7500)
SURROUND: 185 W per channel
1)
(with SS-SRP7500)
SURROUND BACK:
185 W per channel
1)
(with SS-SRP7500)
• Power amplifier (TA-KMSW500)
RMS output (6 ohms, 80 Hz, THD 10%)
200 W per channel
1)
Input LINE IN (input pin jacks)
1)
Measured under the following conditions:
2)
Reference power output for front, center, surround
and surround back speakers. Depending on the
sound field settings and the source, there may be
no sound output.
Inputs
Analog Sensitivity: 800 mV/
50 kohms
Digital (Coaxial) Impedance: 75 ohms
If you are unable to remedy the
problem using the
troubleshooting guide
If the problem persist
Reference sections for clearing
the receiver’s memory
To clear See
All memorized settings page 32
Customized sound fields page 60
Area code Power requirements
E51, SA 240 V AC, 50 Hz
EA 127 V AC, 60 Hz
AU 230 V AC, 50 Hz
CA 120 V AC, 60 Hz
continued
To Next Page
Loading...
