What to do if recording cannot be carried out on my Sony HT-M5?
If you cannot record with your Sony Home Theater System, please check the following: * Verify that the equipment is connected correctly. * Select the source equipment using the input buttons. * Note that audio input signals via HDMI IN and DIGITAL IN jacks cannot be recorded. * The source may contain copyright protection to prevent recording.
Why is there no sound, or very low sound, from specific speakers on my Sony Home Theater System?
To resolve this, ensure all cords are fully inserted into the jacks on both the receiver and the equipment. If using analog equipment, connect to both the L and R jacks. Adjust the speaker level. Verify that the speaker cords and the subwoofer are connected correctly and securely.
How to fix severe hum or noise in my Sony Home Theater System?
To address hum or noise, ensure speakers and equipment are securely connected. Keep connecting cords away from transformers, motors, TVs, and fluorescent lights (at least 3 meters/10 feet). Move audio equipment away from the TV. If plugs and jacks are dirty, clean them with a cloth slightly moistened with alcohol.
How to fix unbalanced or reversed left and right sounds on Sony Home Theater System?
Make sure the speakers and equipment are connected correctly and securely. Adjust the level parameters using the LEVEL menu.
What to do if the Control for HDMI function does not work on my Sony Home Theater System?
If the Control for HDMI function is not working on your Sony Home Theater System, verify the following: * Check the HDMI connection. * Make sure “CTRL.HDMI” is set to “CTRL ON” in the HDMI menu. * Ensure the connected equipment is compatible with the Control for HDMI function.
What to do if when the Sony HT-M5 Home Theater System receiver is in standby mode, there is no image output from the TV?
When your Sony Home Theater System receiver is in standby mode and there is no image output from the TV: * Images are from the last HDMI equipment selection before you turned off the receiver. * Make sure “PASS.THRU” is set to “ON”. * Try pressing the input button on the remote control or turning INPUT SELECTOR on the receiver to select the equipment of your choice. * When you want to listen to the sound from the TV speaker, set the “AUDIO.OUT” to “TV+AMP” in the HDMI menu. * Sound may be interrupted when the equipment not compatible with the “BRAVIA” Sync is connected to the receiver.
Why radio stations cannot be tuned in on my Sony HT-M5 Home Theater System?
To address this, check that the antennas are securely connected. Adjust the antennas and connect an external antenna if needed. If automatic tuning has weak signal strength, use direct tuning. Ensure you set the tuning scale correctly when tuning in AM stations with direct tuning. If no stations have been preset or have been cleared, preset the stations. Press DISPLAY repeatedly so that the frequency appears on the display panel.
Why no 3D image appears on the TV with my Sony Home Theater System?
Depending on the TV or the video equipment, 3D images may not be displayed.
What to do if the remote control does not function with my Sony Home Theater System?
To resolve this, point the remote control directly at the remote control sensor on the receiver. Ensure there are no obstructions between the remote and the receiver. If the batteries are weak, replace them with new ones. Also, verify that you have selected the correct input on the remote control.
What to do if there is no sound from a specific equipment connected to my Sony HT-M5?
If there is no sound from a specific equipment connected to your Sony Home Theater System, check the following: * Ensure the equipment is correctly connected to the audio input jacks for that equipment. * Verify the connecting cord(s) are fully inserted into the jacks on both the receiver and the equipment. * Check the INPUT MODE. * Check the setting of “AUDIO.OUT” in the HDMI menu. * Confirm the equipment is correctly connected to the HDMI jack for that equipment. * Note that you cannot listen to Super Audio CD by connecting HDMI.
Instructions for installing batteries into the remote control.
Details and diagrams of the front panel components.
Diagrams and labels for the rear panels of HT-M7 and HT-M5.
Diagrams and labels for the rear panel of the HT-M3.
Details on operating the remote control, including button functions and models.
Explanation of receiver operation using the remote control buttons.
Instructions for controlling a Sony TV using the remote.
Step-by-step guide for initial setup and connecting equipment.
Guide to installing front, surround, and subwoofer speaker systems.
Diagrams for connecting speakers to the HT-M7 receiver.
Diagrams for connecting speakers to the HT-M5 receiver.
Diagrams for connecting speakers to the HT-M3 receiver.
Guide to connecting the TV using HDMI, component, or video signals.
Instructions and features for connecting video equipment via HDMI.
Guide to connecting equipment using optical, coaxial, component, and video jacks.
Diagrams for connecting VCRs and DVD recorders.
Guide to connecting CD players and portable audio devices.
Instructions for connecting a USB device to the receiver.
Guide to connecting FM and AM antennas to the receiver.
Instructions for setting the voltage selector on the receiver.
Steps for connecting the AC power cord to a wall outlet.
Procedure for resetting the receiver to factory default settings.
Guide to selecting optimal surround speaker placement.
Using test tone to adjust speaker levels and balance.
Steps for selecting and playing audio/video sources.
List of compatible Sony USB devices and file format support.
Instructions for controlling USB playback using the remote.
How to view receiver status and applied sound fields on the display.
Steps for recording audio/video from connected equipment.
Guide to tuning into FM and AM radio stations.
Instructions for saving favorite radio stations as presets.
Guide to choosing optimized sound fields for different content.
Procedure to reset sound fields to their original default settings.
Explanation of the BRAVIA Sync function and its benefits.
Guide to setting up BRAVIA Sync for TVs compatible with HDMI-Easy Setting.
How to automatically play connected equipment with one touch.
Using System Audio Control to output TV sound through receiver speakers.
How to automatically turn off the receiver when the TV is turned off.
Switching sound fields based on selected TV scenes.
Guide to selecting between digital and analog audio input.
Navigating and customizing receiver settings via the menu.
Details of available menus, parameters, settings, and default values.
Guide to adjusting individual speaker levels and balance.
Setting surround speaker position and speaker distance.
Adjusting bass and treble levels for front speakers.
Instructions for naming preset radio stations.
Adjusting audio delay to match video synchronization.
Selecting audio languages for digital broadcasts.
Setting the audio input mode (AUTO, COAX, OPT, ANALOG).
Enabling or disabling the Control for HDMI function.
Configuring HDMI signal pass-through settings.
Adjusting the brightness of the receiver's display panel.
Configuring the receiver to automatically enter standby mode.
Important safety, power source, heat, and placement precautions for the receiver.
Troubleshooting steps for the receiver turning off automatically.
Troubleshooting steps for no image or 3D image display problems.
Troubleshooting steps when no image is output while the receiver is in standby.
Troubleshooting steps when recording fails.
Troubleshooting steps for no sound or very low sound output.
Troubleshooting steps for interference causing hum or noise.
Troubleshooting steps for unbalanced or reversed audio output.
Troubleshooting steps when sound is missing from a particular device.
Troubleshooting steps for weak FM radio signal reception.
Troubleshooting steps when radio stations cannot be tuned.
Problems encountered with unsupported USB devices.
Troubleshooting steps for noise, skipping, or distorted sound with USB devices.
Troubleshooting steps when the USB device is not detected.
Troubleshooting steps when USB playback does not start.
Troubleshooting steps for unsupported audio file formats.
Explanation and resolution for the PROTECT error message.
Explanation and resolution for the USB FAIL error message.
Technical specifications for the amplifier section, including power output.
Tuning ranges and antenna requirements for FM and AM tuners.
Specifications for video inputs and outputs.
Details on front speaker units for HT-M7/HT-M5 and HT-M3.
Details on subwoofer units for HT-M7/HT-M5 and HT-M3.
Details on center speaker units for HT-M7/HT-M5/HT-M3.
Details on surround back/surround speaker units.
Instructions for installing batteries into the remote control.
Details and diagrams of the front panel components.
Diagrams and labels for the rear panels of HT-M7 and HT-M5.
Diagrams and labels for the rear panel of the HT-M3.
Details on operating the remote control, including button functions and models.
Explanation of receiver operation using the remote control buttons.
Instructions for controlling a Sony TV using the remote.
Step-by-step guide for initial setup and connecting equipment.
Guide to installing front, surround, and subwoofer speaker systems.
Diagrams for connecting speakers to the HT-M7 receiver.
Diagrams for connecting speakers to the HT-M5 receiver.
Diagrams for connecting speakers to the HT-M3 receiver.
Guide to connecting the TV using HDMI, component, or video signals.
Instructions and features for connecting video equipment via HDMI.
Guide to connecting equipment using optical, coaxial, component, and video jacks.
Diagrams for connecting VCRs and DVD recorders.
Guide to connecting CD players and portable audio devices.
Instructions for connecting a USB device to the receiver.
Guide to connecting FM and AM antennas to the receiver.
Instructions for setting the voltage selector on the receiver.
Steps for connecting the AC power cord to a wall outlet.
Procedure for resetting the receiver to factory default settings.
Guide to selecting optimal surround speaker placement.
Using test tone to adjust speaker levels and balance.
Steps for selecting and playing audio/video sources.
List of compatible Sony USB devices and file format support.
Instructions for controlling USB playback using the remote.
How to view receiver status and applied sound fields on the display.
Steps for recording audio/video from connected equipment.
Guide to tuning into FM and AM radio stations.
Instructions for saving favorite radio stations as presets.
Guide to choosing optimized sound fields for different content.
Procedure to reset sound fields to their original default settings.
Explanation of the BRAVIA Sync function and its benefits.
Guide to setting up BRAVIA Sync for TVs compatible with HDMI-Easy Setting.
How to automatically play connected equipment with one touch.
Using System Audio Control to output TV sound through receiver speakers.
How to automatically turn off the receiver when the TV is turned off.
Switching sound fields based on selected TV scenes.
Guide to selecting between digital and analog audio input.
Navigating and customizing receiver settings via the menu.
Details of available menus, parameters, settings, and default values.
Guide to adjusting individual speaker levels and balance.
Setting surround speaker position and speaker distance.
Adjusting bass and treble levels for front speakers.
Instructions for naming preset radio stations.
Adjusting audio delay to match video synchronization.
Selecting audio languages for digital broadcasts.
Setting the audio input mode (AUTO, COAX, OPT, ANALOG).
Enabling or disabling the Control for HDMI function.
Configuring HDMI signal pass-through settings.
Adjusting the brightness of the receiver's display panel.
Configuring the receiver to automatically enter standby mode.
Important safety, power source, heat, and placement precautions for the receiver.
Troubleshooting steps for the receiver turning off automatically.
Troubleshooting steps for no image or 3D image display problems.
Troubleshooting steps when no image is output while the receiver is in standby.
Troubleshooting steps when recording fails.
Troubleshooting steps for no sound or very low sound output.
Troubleshooting steps for interference causing hum or noise.
Troubleshooting steps for unbalanced or reversed audio output.
Troubleshooting steps when sound is missing from a particular device.
Troubleshooting steps for weak FM radio signal reception.
Troubleshooting steps when radio stations cannot be tuned.
Problems encountered with unsupported USB devices.
Troubleshooting steps for noise, skipping, or distorted sound with USB devices.
Troubleshooting steps when the USB device is not detected.
Troubleshooting steps when USB playback does not start.
Troubleshooting steps for unsupported audio file formats.
Explanation and resolution for the PROTECT error message.
Explanation and resolution for the USB FAIL error message.
Technical specifications for the amplifier section, including power output.
Tuning ranges and antenna requirements for FM and AM tuners.
Specifications for video inputs and outputs.
Details on front speaker units for HT-M7/HT-M5 and HT-M3.
Details on subwoofer units for HT-M7/HT-M5 and HT-M3.
Details on center speaker units for HT-M7/HT-M5/HT-M3.
Details on surround back/surround speaker units.
General| Brand | Sony |
|---|---|
| Model | HT-M5 |
| Category | Home Theater System |
| Language | English |
To Next Page
