29
GB
Saving Power
Consumption
To use the system while saving power
consumption, change the following
settings.
When you set the auto standby function
to on, the system enters standby mode
automatically when you do not operate
the system for about 20 minutes and
the system is not receiving an input
signal.
Set “SYS >” – “ASTBY” on the system to
“ON” (page 26).
The default setting is “OFF.”
To save power consumption during the
standby mode, set “BTSTB”
(BLUETOOTH standby) (page 26) and
“CTRL” (Control for HDMI) (page 25) to
“OFF.”
The default settings for them are “ON.”
Turn the System Off by
Detecting the Using State
Saving Power in Standby
Mode
To Next Page
Loading...
