Sony ICF-6800W - Page 36

ICF-6800W |
20
15
10
ycm)
0
an
(inch)
0
MIDDLE-CASE REMOVAL (Page 27)
@ SCALE-DRUM DIAL-CORD STRINGING
1. Dial-Cord Preparation
1,2171mm
(47-11/16°)
”
9-911-825-52
Cord, dial; 0.25mm dia.
2. Dial-Cord Stringing
4 turns
drum (B)
scale drum
@ Set the scale drum to
the full-counterclock wise
stop.
@ Set the gear (A) to the
full-counterclockwise stop.
gear (A)
(MW/SW selector)
3. Dial-Scale Setting
1) Hold the gear (A) and strongly move the scale
drum so that the cursor on the transparent plate
places on the dial scale when the SCALE ADJ
knob is turned to the left- and right-most stops.
Note: The dial cord slips on the drum (B).
SCALE ADJ knob
turned to the
/eft-most stop
SCALE ADJ turned
to the right-most stop
WEI sca& ADJ knob
leftward <———® rightward
— 38 —
2) Adjust the SCALE ADJ knob so that the cursor
places on the position shown by (A)
3) Set the gear (A) to the full-counterclockwise stop.
Hold the gear (A) and move the scale drum strong-
ly so that the dial scale places at the position as
shown below.
cursor
just on the
right-most edge
of the figure “0”