1-10 (E)
ICP-6520/6530/3000/6511
1-5. Installing Menu Panel
The menu panel ICP-6511 can be installed to the monitor
arm compliant with VESA Standard using the adapter
supplied with ICP-6511. See the dimensions for installation
below.
Adapter installation dimensions
(compliant with VESA Standard)
The following parts supplied with ICP-6511 are required to
install the menu panel.
n
Use the specified accessories when installing the menu
panel.
. Adapter
. USB cable
. Screws (B3 x 6): 4 pcs
. Screws (B4 x 8): 4 pcs
100 mm
75 mm
4-M4
4-M4
100 mm
75 mm
Installation
n
Connect the attached 50-pin cable to the menu panel, and
then perform the following steps.
1. Install the adapter to the menu panel with the attached
four screws (B3 x 6).
2. Install a commercially available monitor arm to the
adapter with the attached four screws (B4 x 8).
n
For installation of monitor arm, refer to its Operation
Manual.
PSW3 x 6
PSW3 x 6
Adapter
Menu panel
DVI-D cable
AC adapter
cable
USB cable
100 mm
75 mm
75 mm
Adapter
Monitor arm
PSW
4 x 8
PSW
4 x 8
100 mm
To Next Page
Loading...
