Press the [UTIL/SBOX] assigned to the 1st row,
turning it on.
Press one of the bank switching buttons
(
1
“Bank
switching buttons” (p. 276)), to select the bank.
Supports banks 1 to 5, numbered from left to right.
Banks cannot be selected on the cross-point control
block of the ICP-3000/3016.
Press the cross-point button to which the desired
shotbox is assigned.
Chapter
14
Utility/Shotbox
Executing a Shotbox Function with
Cross-Point Buttons in the 2nd Row
You can use the bank 2nd row for utility/shotbox
operations.
Notes
To use this function, you must first assign the utility/
shotbox function switch button [UTIL/SBOX] to the 1st
row.
For details about the assignment,
1
“Assigning a Bus or
Function to 1st Row Buttons” (p. 340).
You can assign any shotbox register to the cross-point
buttons.
For details about the assignment,
1
“Assigning a
Function to 2nd Row Cross-Point Buttons” (p. 336).
Shotbox Register Editing
You can carry out the following editing on shotbox
registers.
•
Lock: Write-protect the contents of the register.
•
Copy: Copy the contents of one register to another
register.
•
Move: Move the contents of one register to another
register.
•
Swap: Swap the contents of two registers.
•
Delete: Delete the contents of a register.
•
Name: Attach a name to a register.
The procedures for shotbox register editing are similar to
the procedures described in “Effect Register Editing”
(
1
p. 264).
Unlike in effect register editing, however, it is not
necessary to specify a region in shotbox register editing.
To Next Page
Loading...
