Need help?Do you have a question about the Sony KV-HR36M31 and is the answer not in the manual?
General| Screen Size | 36 inches |
|---|---|
| Display Technology | CRT |
| Aspect Ratio | 16:9 |
| Tuner | Analog |
| Inputs | Component, Composite, S-Video |
| Resolution | 1080i |
Provides an overview of the self-diagnosis feature and its capabilities.
Lists diagnosis items, blink counts, probable causes, and detected symptoms.
Explains how the indicator blinks to show diagnosis items and their counts.
Details how to access and interpret the self-diagnosis screen for past malfunctions.
Explains how to clear results and end the self-diagnosis screen.
Instructions for removing the rear cover assembly.
Steps for removing the main chassis assembly.
Procedure for placing the chassis in a service-friendly position.
Instructions for removing the speaker box assembly.
Steps for removing the T and UG boards.
Instructions for removing the BM and MG boards.
Steps for removing the A board.
Instructions for removing the D board.
Steps for removing the SF board.
Instructions for removing H3, H4, H5, and HMG boards.
Diagram showing the arrangement of various harnesses within the unit.
Detailed procedure for safely removing the anode cap.
Diagram and notes on removing the CRT assembly and its parts.
Procedure for setting the TV into service adjustment mode using the remote.
Details on adjusting parameters within the service mode.
Method to confirm that adjustments have been saved to memory.
Comprehensive list of service mode parameters and their ranges.
Procedure to initialize SFC data before making adjustments.
Steps for adjusting beam landing using a white signal and purity control.
Procedure for adjusting horizontal and vertical static convergence.
Steps for adjusting dynamic convergence for red and blue mis-alignment.
Procedure to adjust G2 voltage for optimal picture brightness.
Steps for initial focus adjustment using a monoscope pattern.
Procedure to adjust the neck assembly twist for optimal dot shape.
Procedure for coarse adjustment of convergence and landing points.
Detailed steps for adjusting landing uniformity on screen edges.
Details on adjusting convergence ranges from selected points to center.
Procedure for fine adjustment of landing and convergence.
Fine adjustment steps for convergence in fine mode.
Procedure for adjusting P&P sub contrast for VIDEO signals.
Procedure for adjusting P&P sub hue and sub-color for VIDEO signals.
Procedure to adjust white balance for accurate color reproduction.
Second focus adjustment step, checking magenta ring and tracking.
Adjustments for picture distortion using DEF1 and DEF2 modes.
Procedure to confirm the maximum +B voltage level.
Adjusting HV regulation circuit components for safety.
Adjusting HV protector circuit for safety and proper operation.
Checking the IK protector circuit on the D board for safety.
To Next Page