Sony LBT-A795 - Page 3

SERVICE MANUAL
This set is the Preamplifier
section in LBT-A790/A795.
A-AT90E
AEP Model
E Model
Australian Model
Tourist Model
SPECIFICATIONS
an an Power consumption 1sW
Audio input —_| Jack type Sensitivity Impedance Mass ‘Approx. 3.9 kg (6 Ibs 10 02)
VIDEO 1/MD | Phono 435 mV 47 kohms Dunensions Baris perpen
VIDEO 2/DAT | Phono 435 mV 47 kohms (w/h/d, facluding projections)
VIDEO3 Phono 245 mV 47 kohms : Bey
PHONO (MM) | Phono 33mV 47 kohms
MIC Phone ImVv 10 kohms Design and specifications are subject to change without notice.
Audio output | Jack type Voltage Impedance
Abbreviations
VIDEO 1/MD_ | Phono 235 mV 2kohms G German model
VIDEO 2/DAT | Phono 235 mV 2 kohms IT: Italian model
CENTER OUT | Phono AUS: Australian model
EA : Saudi Arabia model
Nae 5 MY : Malaysia model
Video input (phono jacks) SP: Singapore model
VIDEO 1/MD, VIDEO 2/DAT, VIDEO 3 “TEs Le rganiat ehedal
1 Vp-p, 75 ohm unbalanced, sync WS Maca Badal
negative
Video output (phono jacks)
VIDEO 1/MD 1 Vp-p, 75 ohm unbalanced, syne
negative
VIDEO 2/DAT 1 Vp-p, 75 ohm unbalanced, sync
negative
MONITOR 1 Vp-p, 75 ohm unbalanced, syne
negative Le SAFETY-RELATED COMPONENT WARNING!!
Frequency response 15 Hz to 20 kHz" dB
Power requirements 220—230V AC, 50/60Hz
(AEP, G, IT, CIS)
240V AC, 50/60Hz (AUS)
110—120V/220—240V AC, 50/60Hz
(, EA, MY, SP, JE)
120V AC, 60Hz (MX)
COMPONENTS IDENTIFIED BY MARK /\ OR DOTTED LINE WITH
MARK /{\ ON THE SCHEMATIC DIAGRAMS AND IN THE PARTS LIST
ARE CRITICAL TO SAFE OPERATION. REPLACE THESE COMPONENTS
WITH SONY PARTS WHOSE PART NUMBERS APPEAR AS SHOWN IN
THIS MANUAL OR IN SUPPLEMENTS PUBLISHED BY SONY.
DIGITAL STEREO PREAMPLIFIER
SONY.