Getting Started
13
GB
6 Connect the video input jack of your TV
to the VIDEO OUT jack with the
supplied video cable.
MONITOR OUT
VIDEO
S VIDEO
(DVD ONLY)
When using a TV
Turn on the TV and select the video input so
that you can view the pictures from this system.
Tip
For even higher quality video images, you can use an
optional S-video cable to connect the S VIDEO input
jack on your TV to the S VIDEO OUT jack (DVD
only).
7 For models with a voltage selector, set
VOLTAGE SELECTOR to the local
power line voltage.
Depending on the model, the VOLTAGE
SELECTOR may differ.
220V230-240V120V*
VOLTAGE SELECTOR
* Saudi Arabian model: 120 – 127 V
8 Connect the power cord to a wall outlet.
The demonstration appears in the display.
When you press ?/1, the system turns on
and the demonstration automatically ends.
If the supplied adapter on the plug does not
fit your wall outlet, detach it from the plug
(only for models equipped with an adapter).
9 (Except for Pan-American and
European models)
Set the color system to PAL or NTSC
depending on the color system of your
TV.
The color system is factory set to NTSC for
region code 3 models, and PAL for other
region code models. Each time you perform
the procedure below, the color system
changes as follows:
NTSC y PAL
Use the buttons on the system.
1 Press ?/1 to turn off the system.
2 Press ?/1 while holding down X.
The system turns on and the color system is
changed.
Notes
• You cannot set the color system in the Power
Saving Mode.
• When you play back a VIDEO CD recorded in a
different color system from the one you set to the
unit, the picture image may be distorted.
To connect optional components
See page 61.
continued
To Next Page
Loading...
Need help?
General
