1-9
MVS-8000X/7000X
2. While the rear levers are opened, remove the blank
panel.
m
. Store the removed blank panel in a safe place.
. In case there is a blank panel consecutive in steps
above (in a unit), remove these blank panel too.
Rear lever
Rear lever
Blank panel
Unit
In case there is a blank panel consecutive in steps
above (in a unit), remove these blank panel too.
This figure shows MVS-8000X
3. While the rear levers are opened as shown in the
illustration, insert the plug-in board into the board
guide rail.
n
Insert making sure the board's upper and lower spring
plates do not catch on the board.
Spring plate
Plug-in board
This figure shows MVS-8000X
4. Push the rear levers inward until a click sound is made
and they are locked.
Rear lever
Rear lever
This figure shows MVS-8000X
MVS-8000X Option List
Name of option Name of board Slot on the rear side
MKS-8110X CNI-37 board 6, 7, 8, 9, 10, 11
MKS-8160X CNO-38 board 14
MKS-8170X CNI-37 board 1
CNO-37 board 2
MKS-8180X CNI-37 board 3
MKS-8440X CN-3235 board 16
MVS-7000X Option List
Name of option Name of board Slot on the rear side
MKS-7171X CNO-37 board 3
MKS-8110X CNI-37 board 2, 6, 7, 8
MKS-8160X CNO-38 board 10
MKS-8440X CN-3235 board 12
5. Install the blank panel removed once in the slot on one
step.
To Next Page
Loading...
