1-13
MVS-8000X/7000X
1-5-2. MVS-7000X
To mount the MVS-7000X in the rack, use the specifi ed
rack mount kit and follow the procedure described below.
Specifi ed rack mount kit: RMM-10
n
If other than the specifi ed rack mount kit is used, the unit
may not be mounted in the 19-inch standard rack.
Part of the RMM-10
. Rack tool 2 pcs
. Right rack mount adapter 1 pc
. Left rack mount adapter 1 pc
. Rack tool attaching screw
(+B4 x 6 : 7-682-560-09) 6 pcs
. Adapter attaching screw
(+B4 x 10: 7-682-560-10) 6 pcs
Other requlred parts
To mount in the rack, the rack mount kit RMM-10 and the
following part are required.
. Screw for rack mounting
(+B5 x 12: 7-682-576-09) 4 pcs
Rack Mounting Procedure
1. Loosen the four screws (+B4 x 8) and remove the four
feet.
Feet
Feet
+B4 x 8
+B4 x 8
2. Remove the front panel of the equipment.
(Refer to Section 1-4-1.)
3. Attach the rack tool to the side of the equipment using
the specifi ed six screws.
n
Use +B4 x 6 screws. Tighten the screws to the follow-
ing torque.
Tightening torque: 120 x 10
-2
N.m {12.2 kgf.cm}
B4 x 6
Rack tool
Rack tool
B4 x 6
To Next Page
Loading...
