Sony MVS-8000X-C - Page 18

1-12
MVS-8000X/7000X
4 Attach the bracket to the support angle by inserting the
specifi ed four screws and loosely tightening.
5. Loosen the screws on the rear of the right and left
adapters and adjust the length of the adapter accordin
to the depth of the rack.
+PSW4 s10
+PSW4 s10
Bracket
Bracket
Support angle
n
Maximum depth of bracket : 750 mm
Minimum depth of bracket : 545 mm
6. Attach the right and left adapters to the rack complete-
ly using the specifi ed eight screws.
(The illustration below shows the left adapter.)
7. Tighten the screws (+PSW4 x 10 : four screws each
on the right and left) for adjusting the length of the
adapter completely (the screws that were loosened in
step 5).
+PSW4 s10
+PSW4 s10
+B4 s10
+B4 s10
31.75
15.9
Front side
Rear side
Unit:mm
8. Align the groove of the rack tool at the side of the
equipment with the rail, and slide the equipment to the
rear.
n
The rack tools are hooked on the rails as shown below.
Support angle Support angle
Rack tool Rack tool
9. Fix the rack angle in the rack using the specifi ed
screws.
+B5 s12
+B5 s12
10. Attach the front panel to the equipment.
(Refer to Section 1-4-1.)