— 24 —
Mode: 200
Function mode
Mode: 210
Mechanism check
Mode: 211
EJECT prohibit
Mode: 212
Magnetic head ON
”
key
p
key
”
key
”
key
”
key
p
key
p
key
Mode: 310
Power supply identification test
Mode: 300
Power supply mode
mode:311
Li-ion
mode:312
AM 3
mode:313
DC IN
”
key (automatic identification)
”
key
p
key
p
key
p
key
”
key
”
key
p
key
ASSYFF
040
1SHUF
040
FF
SHUF
Overall adjustment mode
”
key (CD or MO identification)
CD automatic
adjustment
MO automatic
adjustment
OK
OK
NG
NG
p
key
p
key
p
key
p
key
Overall Adjustment Mode
• How to enter the overall adjustment mode
After entering the test mode, press the = key to enter the
overall adjustment mode.
• To enter the other modes of the test mode, exit the test mode
once, and re-enter the test mode again.
• When the machine enters the overall adjustment mode, the LCD
display on the remote control unit and on the station appears as
shown below.
< LCD display on remote control >
< LCD display on the machine >
• Overall adjustment mode configuration
Function Mode
• How to enter the function mode
After entering the test mode, while pressing + key, press the
VOLUME + key and VOLUME – key to enter the function
mode.
• To enter the other modes of the test mode, re-enter the test mode
again. Refer to the section [Test mode configuration].
• Function mode configuration
• When the machine enters the function mode Nos. 200, 210 to
212, the optical pickup moves to the outer circumference and
to the inner circumference respectively by pressing the =
key and + key.
Power Supply Mode
• How to enter the power supply mode
After entering the test mode, while pressing + key, press the
VOLUME + key and VOLUME – key to enter the power supply
mode.
• To enter the other modes of the test mode, re-enter the test mode
again. Refer to the section [Test mode configuration].
• Power supply mode configuration
To Next Page
Loading...
