Sony PDW-680 - Setting the Area of Use

Setting the Area of Use
19
When using the unit for the first time
The area of use is not factory preset. Before using
this unit, you need to set this item. (You cannot
use the unit without setting this item.)
To set the area of use
1 Set the POWER switch to the ON
position.
The screen for setting the area of use appears
in the viewfinder.
2 Press the MENU knob.
z on the left of NOT SELECTED changes to
?, and you can now select the area of use.
3 Turn the MENU knob to display the
desired area of use.
a) The composite signal output from this unit is an
NTSC signal with no black setup. The system
frequency is 59.94i.
b) The composite signal output from this unit is an
NTSC signal with a black setup (7.5 IRE). The
system frequency is 59.94i.
c) The composite signal output from this unit is a
PAL signal. The system frequency is 50i.
4 Set the POWER switch to OFF, then
once again to ON.
The unit is now ready for use.
Setting the Area of Use
MENU knob
POWER switch
COUNTRY : NOT SELECTED
SYSTEM LINE : 1080
SET FORMAT
AND TURN OFF ONCE.
FORMAT SETTING
FORMAT SETTING
COUNTRY :?NOT SELECTED
SYSTEM LINE : 1080
SET FORMAT
AND TURN OFF ONCE.
Setting Area of use
NTSC(J)AREA
NTSC area (Japan)
a)
NTSC AREA NTSC area (for areas other
than Japan)
b)
PAL AREA
PAL area
c)